Simple Cycle definition

Simple Cycle means operation of a Combustion Turbine without capturing the waste heat from the Combustion Turbine in the associated heat recovery steam generator and, therefore, without producing additional Net Energy from the steam turbine utilizing steam produced by such heat recovery steam generator. When one or more CTs are operated in Simple Cycle mode, the Facility will produce less Capacity and less Net Energy, while consuming Fuel at a higher heat rate, than when the Facility is operated in combined cycle mode to produce Baseload Capacity. The ramp rates applicable to each CT, as set forth in Exhibit R, are faster in Simple Cycle mode than in combined cycle mode.
Simple Cycle means operation of a Combustion Turbine without capturing the waste heat from the Combustion Turbine in the associated heat recovery steam generator and, therefore, without producing additional Net Energy from the steam turbine utilizing steam produced by such heat recovery steam generator. When one or more CTs are operated in Simple Cycle mode, the Facility will produce less Capacity and less Net Energy, while consuming Fuel at a higher heat rate, than when the Facility is operated in combined cycle mode to produce Baseload Capacity. The ramp rates applicable to each CT, as set forth in Exhibit Q, are faster in Simple Cycle mode than in combined cycle mode.
Simple Cycle. The operation of the Facility without the ST operating. Site - The contiguous piece of real property upon which the electric operation and related non-real property portions of the Facility are located, as further described in Section 2.1C. Site Rep - HELCO's representative as described in Section 9.5. Spinning Reserve - The difference between the load currently carried on the Facility while synchronized and on-line and the Facility's Net Maximum Capacity, both measured at the same instant in time. Substation - The assemblage of equipment that switches and/or changes or regulates the voltage of electricity delivered to HELCO's electrical system from the Facility as indicated in "Attachment A." ST - The steam turbine and related equipment.

Examples of Simple Cycle in a sentence

  • Table 1: Cold Start-Up Cost for Simple Cycle > 90 MW Resources Note: Units 5, 6 and 7 are under a PPA, therefore, their O&M are capped In Table 1 above, the Cap is established by Unit 4 at $9,000.

  • If the requisite regulatory approvals are not timely obtained, DEF cannot purchase the Osprey Plant and intends to complete the Suwannee Simple Cycle Project in the alternative.

  • Components of Simple Cycle Gas TurbineHigher temperature and pressure ratios result in higher efficiency and specific power, or power-to- weight ratio.

  • Simple Cycle combustion turbines used as peaking generation may be exempted from the MVAR absorption requirements.

  • These consultants are scheduled to be onboard by March/April 2015, well in time to interface with commissioning of the Simple Cycle Power plant.

  • Table 2: Hot Start-Up Cost for Simple Cycle > 90 MW Resources (1) Costs for a hot start is calculated by multiplying a Relative Weight 0.5 by the cost for a cold start In Table 2 the highest cost of the four non-PPA Resources is that of Unit 1 ($6,650); thus the Cap for the PPA Units is set at this level.

  • Alternatively, if DEF builds the Suwannee Simple Cycle Project, the Company’s Reserve Margin will be 20.7 percent in the summer of 2017.

  • The plant’s net capacity under the PPA definition is 341 MW on combined cycle operation and 222 MW on Simple Cycle Operation at reference site conditions.

  • The major components of the plant consisted of a Simple Cycle Gas Turbine with Generator, Control Room, 132/11kV Power Transformer, 132 KV Switch yard, Liquid Fuel System, Natural Gas Fuel System, Lubricating System, Cooling System, Water Treatment Plant, Effluent Treatment Plant and other associated accessories.

  • Based on the CPVRR analysis, the Company initially chose the Suwannee Simple Cycle Project and the Hines Chillers Power Uprate Project as its base generation plan to meet the Company’s reliability needs prior to 2018.


More Definitions of Simple Cycle

Simple Cycle means a combustion turbine electric generating unit which does not recover heat from the combustion turbine electric generating unit exhaust gases to preheat the inlet combustion air to the combustion turbine electric generating unit, to heat water, or to generate steam.

Related to Simple Cycle

  • life cycle means all consecutive and/or interlinked stages, including research and development to be carried out, production, trading and its conditions, transport, use and maintenance, throughout the existence of the product or the works or the provision of the service, from raw material acquisition or generation of resources to disposal, clearance and end of service or utilisation;

  • Distribution Period means, as to any securities or combination of securities, each period from and including a Distribution Date for such securities to but not including the next succeeding Distribution Date for such securities.

  • motor cycle means any two-wheeled vehicle, with or without side-car, which is equipped with a propelling engine. Contracting Parties may also treat as motor cycles in their domestic legislation three-wheeled vehicles whose unladen mass does not exceed 400 kg. The term "motor cycle" does not include mopeds, although Contracting Parties may treat mopeds as motor cycles for the purpose of the Convention.

  • Benefit Distribution Date means the date upon which all or an objectively determinable portion of a Participant’s vested benefits will become eligible for distribution. Except as otherwise provided in the Plan, a Participant’s Benefit Distribution Date shall be determined based on the earliest to occur of an event or scheduled date set forth in Articles 4 through 9, as applicable.

  • Election cycle means the period beginning on the first day persons are eligible to

  • Tax Limitation Period means the Tax Years for which the Applicant’s Qualified Property is subject to the Tax Limitation Amount and as further identified in Section 2.3.D of this Agreement.

  • Distribution Calendar Year means a calendar year for which a minimum distribution is required. For distributions beginning before the Participant's death, the first "distribution calendar year" is the calendar year immediately preceding the calendar year which contains the Participant's "required beginning date." For distributions beginning after the Participant's death, the first "distribution calendar year" is the calendar year in which distributions are required to begin under Section 6.8(b). The required minimum distribution for the Participant's first "distribution calendar year" will be made on or before the Participant's "required beginning date." The required minimum distribution for other "distribution calendar years," including the required minimum distribution for the "distribution calendar year" in which the Participant's "required beginning date" occurs, will be made on or before December 31 of that "distribution calendar year."

  • Plan Year means the calendar year.

  • Performance Cycle means one or more periods of time, which may be of varying and overlapping durations, as the Administrator may select, over which the attainment of one or more Performance Criteria will be measured for the purpose of determining a grantee’s right to and the payment of a Restricted Stock Award, Restricted Stock Units, Performance Share Award or Cash-Based Award, the vesting and/or payment of which is subject to the attainment of one or more Performance Goals. Each such period shall not be less than 12 months.

  • Compliance cycle means the nine-year calendar year cycle during which public water systems shall monitor. Each compliance cycle consists of three three-year compliance periods. The first calendar year cycle began January 1, 1993 and ends December 31, 2001; the second begins January 1, 2002 and ends December 31, 2010; the third begins

  • Initial Enrollment Period means one of the following periods during which you may first enroll for coverage under this plan:

  • Experience period means the most recent period of time for which experience is reported, but not for a period longer than three (3) full years. (7-1-93)

  • Beginning farmer means an individual, partnership, family farm corporation, or family farm limited liability company, with a low or moderate net worth that engages in farming or wishes to engage in farming.

  • Leave Year means the year ending with the anniversary date of the employee’s appointment.

  • Contribution Period means a period in respect of which contributions appropriate to the benefit in question are payable, have been paid or treated as paid under the legislation in question;