Reduction level definition

Reduction level means a reduction efficiency in percent to be met by the retrofit emission control device (RECD) in order to be certified as meeting the reduction level specified in paragraph 4.8.2.
Reduction level means a reduction efficiency in per cent to be met by the retrofit emission control device (REC) in order to be certified as meeting the reduction level specified in paragraph 8.3. of this Regulation.
Reduction level means a reduction efficiency in percent to be met by the retrofit emission control device (REC) in order to be certified as meeting one of the reduction levels specified in Section 3;

Examples of Reduction level in a sentence

  • SharpnessControls the detail of the image for Video (not available for RGB).Video Adjust (not available for RGB)Noise Reduction Select one of the three levels for reducing video noise: Low, Me- dium or High.NOTE: The lower the Noise Reduction level, the better the image quality by way of higher video bandwidth.

  • Desired: Reduction level adopted by the state based on climate stabilization levels of 3-5.5 degree increase in temp.

  • Reduction level adopted by the state based on climate stabilization levels of 3-5.5 degree increase in temp.

  • Flipping the picture is recommended only if the camera is mounted upside down.• 3D NR: This radio button allows the user to turn the 3D Noise Reduction feature on or off.• 3D NR Level: This slider allows the user to specify the 3D Noise Reduction level.

  • Table 2 Scenario generation parameters for analysis of production valueS f an Reduction level Stree Nodes 1000 0.35 771 3701 The reduction level in Table 2 is a parameter used in the scenario generation process.

  • A Resource’s dispatch limits at later time points shall be based on its: (A) dispatch limits from the first time point; (B) response rate; (C) minimum generation, or, to the extent that the ISO’s software can support demand sideparticipation, Demand Reduction level; and (D) UOLN or UOLE, whichever is applicable.

  • To determine which CoA provides the best cost-benefit results, plot the implementation cost of each CoA against the OS Hazard Risk Reduction level achieved, if implemented.

  • DOE has data that would indicate that Federal offices in Climate Zones 1a (Miami, Florida) , 4c (Salem, Oregon), and 5a (Chicago, Illinois) as constructed to the requirements of the Federal baseline standard (90.1- 2010) are approximately at the 65% Fossil Fuel Reduction level for government offices.Buildings constructed to be 30% better than 90.1-2007 (as required in the Federal standards if life-cycle cost-effective) will achieve more than 65% Fossil Fuel Reduction level for government offices.

  • Table 6 Parameters for delta-hedgingfT Correlation S f an Reduction level Nodes Stree0.7 -0.2 500 0.12 4058 472 The results from the sensitivity analysis for each interval in the planning period are shown in Table 7.

  • For the analysis below we used the following parameters: Table 5 Parameters for analysis of the production strategyfT Correlation S f an Reduction level Nodes Stree0.7 -0.2 1000 0.12 7395 937 Figures 6 and 7 present examples of expected production and reservoir level re- spectively.


More Definitions of Reduction level

Reduction level means a reduction efficiency in percent to be met by the retrofit emission control device (REC) in order to be certified as meeting one of the reduction levels specified in Section 3; 53.10. "Combined deNOx- particulate filter" means an exhaust aftertreatment system designed to simultaneously reduce emissions of oxides of nitrogen (NOx) and particulate pollutants;

Related to Reduction level

  • Маrgin Level for CFD trading shall mean the percentage of Equity to Necessary Margin ratio. It is calculated as: Margin Level = (Equity / Necessary Margin) x 100%.

  • Margin Level means the percentage Equity to Necessary Margin ratio. It is calculated as (Equity / Necessary Margin) * 100%.