Rated output voltage definition

Rated output voltage means the allowable peak potential, in volts, at the output terminals of the x-ray high-voltage generator.
Rated output voltage means the allowable peak potential, in volts, at the output terminals of

Examples of Rated output voltage in a sentence

  • Rated output, voltage ratio, vector group shall be as specified in technical particulars for design.

  • Thyristor systemChopper- rectifier systemEfficiency (%) Rated output voltage (V)Figure 2-3: Efficiency versus rated output voltage as adopted from Scaini and Veerkamp (2001) Further comparative research, between thyristor and IGBT chopper rectifier systems, was done by Rodriguez and Pontt et.al.

  • Welding current=100 amps, Welding speed= 3.2 mm/sec, Heat input=2.18 kJ/min, Rated output voltage= 25V, Shielding gas used = Argon and Gas flow= 12 lit/min.Since the sheet material to be stamped is heterogeneous in nature, the blank size needs to be predicted accurately to avoid excessive frictional forces underneath the blank holder.

  • Rated output voltage shall be AC 230V±10% over the full range of PV array operating voltages.

  • Input current Isc PV200V900V1000V DC1:24A/DC2:12ADC1:30A/DC2:15A2AC-OutputRated output power Rated output voltage Rated output frequency Max.

  • Rated output voltage: Programmable for either 80 to 240 volts or from 320 to 480 volts depending on 3-phase motor nameplate rating.

  • USGS Digital Line GraphsThe USGS DLGs were selected for the Henniker pilot project since a road class attribute was readily available that allowed trails to be deselected from buffering.

  • Rated output voltage means the allowable peak potential, in volts, at the output terminals of the x-ray high-voltage generator.

  • Rated output voltage shall be programmable for motor ratings from 180 to 240 volts, or from 320 to 480 volts.

  • Rated output voltage shall be maintained during from charger to battery.

Related to Rated output voltage

  • Rated Voltage means the manufacturer’s design voltage at which the transmission system is designed to operate or such lower voltage at which the line is charged, for the time being, in consultation with Transmission System Users;

  • voltage means the root-mean-square value of electrical potential between two conductors.

  • low voltage means the set of nominal voltage levels that are used for the distribution of electricity and whose upper limit is generally accepted to be an a.c. voltage of 1000V ( or a d.c. voltage of 1500 V). [SANS 1019]

  • Generator Forced Outage means an immediate reduction in output or capacity or removal from service, in whole or in part, of a generating unit by reason of an Emergency or threatened Emergency, unanticipated failure, or other cause beyond the control of the owner or operator of the facility, as specified in the relevant portions of the PJM Manuals. A reduction in output or removal from service of a generating unit in response to changes in market conditions shall not constitute a Generator Forced Outage.

  • Forced Outage means any unplanned reduction or suspension of the electrical output from the Project or unavailability of the Project in whole or in part from a Unit in response to a mechanical, electrical, or hydraulic control system trip or operator-initiated trip in response to an alarm or equipment malfunction and any other unavailability of a Unit for operation, in whole or in part, for maintenance or repair that is not a Planned Outage and not the result of Force Majeure.

  • Working voltage means the highest value of an electrical circuit voltage root-mean-square (rms), specified by the manufacturer, which may occur between any conductive parts in open circuit conditions or under normal operating conditions. If the electrical circuit is divided by galvanic isolation, the working voltage is defined for each divided circuit, respectively.

  • Generator Planned Outage means the scheduled removal from service, in whole or in part, of a generating unit for inspection, maintenance or repair with the approval of the Office of the Interconnection in accordance with the PJM Manuals.

  • Planned Outage means the removal of equipment from service availability for inspection and/or general overhaul of one or more major equipment groups. To qualify as a Planned Outage, the maintenance (a) must actually be conducted during the Planned Outage, and in Seller’s sole discretion must be of the type that is necessary to reliably maintain the Project, (b) cannot be reasonably conducted during Project operations, and (c) causes the generation level of the Project to be reduced by at least ten percent (10%) of the Contract Capacity.

  • high voltage means the classification of an electric component or circuit, if its working voltage is > 60 V and ≤ 1500 V DC or > 30 V and ≤ 1000 V AC root mean square (rms).

  • Unplanned Outage refers to the unavailable status of the units of the Power Plant other than Planned Outage. Based on the urgency of the needs of outage, the Unplanned Outage can be classified into five categories: (1) immediate outage; (2) the outage which could be delayed for a short while but the units must exit within six hours; (3) the outage which could be postponed over six hours but the units must exit within seventy-two hours; (4) the outage which could be deferred over seventy-two hours but the units must exit before the next Planned Outage; and (5) the prolonged outage which is beyond the period of the Planned Outage.

  • Potential electrical output capacity means, with regard to a unit, 33 per- cent of the maximum design heat input of the unit.

  • medium voltage means the set of nominal voltage levels that lie above low voltage and below high voltage in the range of 1 kV to 44 kV;

  • Cubic foot of gas means the amount of gas required to fill a cubic foot of space when the gas is at an absolute pressure of fourteen and seventy-three hundredths (14.73) pounds per square inch at a temperature of sixty (60) degrees Fahrenheit.

  • Grade point average or "GPA" means the grade point average earned by an eligible student and reported by the high school or participating institution in which the student was enrolled based on a scale of 4.0 or its equivalent if the high school or participating institution that the student attends does not use the 4.0 grade scale;

  • Excused Outage means any disruption to or unavailability of Services caused by or due to (i) Scheduled Maintenance,

  • Scheduled Outage has the meaning given to it in the Grid Code;

  • Kilowatt-hour or “kWh” shall mean three decimal six million (3.6 10E6) Joule

  • Output means the exposure rate, dose rate, or a quantity related in a known manner to these rates from a brachytherapy source or a teletherapy, remote afterloader, or gamma stereotactic radiosurgery unit for a specified set of exposure conditions.

  • Net Output means all energy and capacity produced by the Facility, less station use and less transformation and transmission losses and other adjustments (e.g., Seller’s load other than station use), if any. For purposes of calculating payment under this Agreement, Net Output of energy shall be the amount of energy flowing through the Point of Delivery.

  • Unscheduled Outage means an outage that is not a result of a Scheduled Outage;

  • Backpressure means a pressure (caused by a pump, elevated tank or piping, boiler, or other means) on the consumer's side of the service connection that is greater than the pressure provided by the public water system and which may cause backflow.

  • High voltage bus means the electrical circuit, including the coupling system for charging the REESS, that operates on a high voltage.

  • Psig means pounds per square inch gauge.

  • Finished water means the water that is introduced into the distribution system of a public water system and is intended for distribution and consumption without further treatment, except as treatment necessary to maintain water quality in the distribution system (e.g., booster disinfection, addition of corrosion control chemicals).

  • Heat Rate means the quantity of BTU’s consumed to produce a kilowatt-hour of energy, calculated as follows:

  • Generator Maintenance Outage means the scheduled removal from service, in whole or in part, of a generating unit in order to perform necessary repairs on specific components of the facility, if removal of the facility meets the guidelines specified in the PJM Manuals.