Power Plant Controller definition

Power Plant Controller is used to regulate and control any combination of inverters, generators, supplemental devices, and associated equipment at a DER plant in order to meet specified setpoints and requirements at the reference point of applicability, as defined by IEEE 1547.
View Source

Examples of Power Plant Controller in a sentence

  • Plane Of Array Irradiance- Primary Meter Status ON/OFF Communications Online Offline Status Plane Of Array Irradiance- Secondary Meter Status ON/OFF Communications Online Offline Status For Facilities equipped with DC tied, behind a solar inverter, Storage Resources the following Power Plant Controller Output Points shall also be reported to Buyer1 Unit Net MW The resource's real power output measured at the low side of the step-up transformer.

  • Can be a decimal if one or 1 For non-DC tied, behind a solar inverter, Storage Resources Buyer may require additional Power Plant Controller Output Points to be reported upon reasonable notice to Seller.

  • Contractor shall conduct the Availability Test and Functional Test for the Facility in accordance with Exhibit 25, and when Contractor believes that the Facility can satisfy the Minimum Capacity Level, Contractor shall conduct the Power Plant Controller Test and the Capacity Test in accordance with Exhibit 14B or Exhibit 14C, as applicable.

  • This test primarily confirms the transmission and receipt of control points between the System Control Center and the Power Plant Controller, and functionality, bandwidth, latency, and security protocols for the data pathways (primary and backup).

  • A real-time Curtailment Signal from National Grid will be transmitted to the Project’s National Grid-approved Power Plant Controller (or other approved communication device) utilizing National Grid-specified communication system protocols.

  • EPC Contractor shall design, procure and install an indoor rack enclosed within the substation control building to house the SCADA master computer, Power Plant Controller (“PPC”), and communication equipment.

  • The Seller shall be required to collect 5‐minute solar output data for the Facility, for purposes of calculating the Solar Site Volatility Metric (as defined below), using their Power Plant Controller or other means proposed by Seller and reasonably accepted by ▇▇▇▇▇.

  • The Generating Facility will use a Power Plant Controller (PPC) which is closed loop logic controller that will dispatch the plant to maintain a specific active and reactive power output at POI.