Population-level NMEC definition

Population-level NMEC. An energy savings calculation approach in which results are based on pre- and post- intervention energy usage data observed at the meter and calculated across a group of sites, rather than a modeled engineering forecast or deemed value (or a Site-level metered savings calculation). For Population-level normalized metered energy consumption (NMEC), measurement methods are fixed before the program starts and apply to all sites in the group in a uniform fashion, as opposed to Site-level NMEC measurement methods which may differ on a site- by-site basis.
View Source

Examples of Population-level NMEC in a sentence

  • Population-level NMEC is used when savings claims are made for a portfolio of projects using fixed, standardized, verifiable measurement methods before the program starts and are uniformly applied to all sites in the group.2 The Seller’s program will consist of multiple projects that will be aggregated to form a portfolio to deliver Distribution Services.

  • For Population-level NMEC projects, the specific measurement method(s) must be determined before the Project begins and applied uniformly to all sites in the Project.

  • Population-level NMEC is used when savings claims are made for a portfolio of projects using fixed, standardized, verifiable measurement methods before the interventions starts and are uniformly applied to all sites in the group.2 The Seller will install multiple projects that will be aggregated to form a portfolio to deliver Distribution Services.

Related to Population-level NMEC

  • Integration Level means the Social Security taxable wage base for the Plan Year, unless the Employer elects a lesser amount in (A) or (B) below.

  • Maximum Concentration Level Assessment means the Maximum Concentration Level Assessment for the purposes of a Basic Comprehensive Certificate of Approval, described in the Basic Comprehensive User Guide, prepared by a Toxicologist using currently available toxicological information, that demonstrates that the concentration at any Point of Impingement for a Compound of Concern that does not have a Ministry Point of Impingement Limit is not likely to cause an adverse effect as defined by the EPA. The concentration at Point of Impingement for a Compound of Concern must be calculated in accordance with O. Reg. 419/05.

  • Action level means a rate of emissions of a hazardous air contaminant as specified in Appendix C or as may be determined under Section 5-261(3) of these regulations. Action Levels are used to determine the applicability of Section 5-261 to stationary sources and shall be derived in accordance with the method prescribed in Appendix E of these regulations.

  • Minimum Level (ML) means the concentration at which the entire analytical system must give a recognizable signal and an acceptable calibration point. The ML is the concentration in a sample that is equivalent to the concentration of the lowest calibration standard analyzed by a specific analytical procedure, assuming that all the method-specified sample weights, volumes and processing steps have been followed.

  • Severity Level means the actual impact of a Defect on a user’s operational environment as further described in the table below.