Peaking factor definition

Peaking factor means the peak daily customer demand factor as determined in accordance with 327 IAC 8-3.3-2.
Peaking factor means (i) the percentage equivalent of that volume of Overdraft Service available from the System for a given period in excess of Uninterruptible Service, which a customer may divert without charge or (ii) such other definition as is set forth in the Rate Schedule.
Peaking factor means two times the existing demand on a system unless a different number is indicated by the historical record.

Examples of Peaking factor in a sentence

  • Peaking factor for sludge pumping based on typical flows anticipated.

  • Daily Peaking factor: reflecting the following: Peak hour flows and maximum month loadings shall be as described in the current Town of Discovery Bay Wastewater Treatment Plant Master Plan Dated February 2013, and all subsequent addendums.

  • Peaking factor shall be calculated using the following formula: PF = 1.25 + [14 ÷ (4 + (P))] where PF is the peaking factor and P is the contributing population in 1,000's.

  • Peaking factor is calculated by dividing maximum monthly summer demand by minimum winter monthly demand in any given year, then averaging these ratios across all years included during the baseline period.

  • If Tenant does not terminate and provided that the Building can be restored to an economically usable unit, this Lease shall remain in effect as to the portion of the Property not taken, except that the Base Rent and Additional Rent shall be reduced in proportion to the reduction in the floor area of the Property.

  • Peaking factor can be calculated using either the Harmon Formula or Babbitt Formula.

  • Special attention has been paid to the 352 major consumers.• Peaking factor for each nodal demand have been entered by considering their pressure zone.Hence, the distribution system has been configured for each sub pressure zone by carefully identifying the location of high domestic and non-domestic customers.Pumps data have been entered into the built model in the following table format.

  • Peaking factor for residential flows can be calculated using either the Harmon Formula or Babbitt Formula.

  • The flux level will be 2×1015 n/s.cm² (Peaking factor ~ 2) with more than 65% of the neutrons above0.1 MeV.

  • LLR: L/m/day Proposed total VS: HLR: L/sqm/day (Basal loading if for mound) Minimum system length = Q/LLR ÷ = Meters Total daily design flow Q = L/Day Peaking factor: 2 Average flow = Q / 2 = L/Day Soil/site information A.


More Definitions of Peaking factor

Peaking factor means a peak day delivery limitation, which such limitation is a not to exceed quantity of water (expressed in million gallons of water per day or "MGD") that is determined by multiplying the uniform daily delivery rate established by a Wholesale Water Supply Agreement by 1.33 (i.e., Peaking Factor = 1.33 x uniform daily delivery rate). The Peaking Factor shall apply to all peak day wholesale water deliveries made by Tacoma to a City pursuant to a Wholesale Water Supply Agreement. By way of example, as applied to a uniform daily delivery rate of 4 MGD, the Peaking Factor limits a maximum peak day delivery to 5.32 MGD.
Peaking factor means a peak day delivery limitation, which such limitation is a not to exceed quantity of water (expressed in million gallons of water per day or "MGD") and that is determined by multiplying the uniform daily delivery rate by 1.33 (i.e., Peaking Factor =
Peaking factor means a measure of the additional system capacity needed to deliver peak water volumes. The peaking factor is stated as the ratio of peak consumption to average consumption.

Related to Peaking factor

  • Weighting factor wT for an organ or tissue (T) means the proportion of the risk of stochastic effects resulting from irradiation of that organ or tissue to the total risk of stochastic effects when the whole body is irradiated uniformly. For calculating the effective dose equivalent, the values of wT are:

  • Load Factor means the percentage of aircraft seats actually occupied on a flight (RPMs divided by ASMs). “NMB” means the National Mediation Board.

  • Stress Factor means 2.25.

  • Seasonal high water table means the highest zone of soil or rock that is seasonally or permanently saturated by a perched or shallow water table. A planar surface, below which all pores in rock or soil (whether primary or secondary) that is seasonally or permanently saturated.

  • Generator to Load Distribution Factor or “GLDF” shall mean a generator’s impact on a Flowgate while serving load in that generator’s Balancing Authority Area.

  • Power Factor means the ratio of usage power measured in kW to total power measured in kVA;

  • Sustainability Factors means environmental, social and employee matters, respect for human rights, anti‐corruption and anti‐bribery matters.

  • Quarterly (1/Quarter) sampling frequency means the sampling shall be done in the months of March, June, August, and December, unless specifically identified otherwise in the Effluent Limitations and Monitoring Requirements table.

  • Leverage Factor means the leverage factor in respect of a Series of ETP Securities as specified in the relevant Final Terms.

  • emission factor means the average emission rate of a greenhouse gas relative to the activity data of a source stream assuming complete oxidation for combustion and complete conversion for all other chemical reactions;

  • Fit factor means a quantitative estimate of the fit of a particular respirator to a specific individual, and typically estimates the ratio of the concentration of a substance in ambient air to its concentration inside the respirator when worn.

  • Class Factor As to any date of determination and any Class of Certificates (other than the Interest Only Classes and the Residual Certificates), a fraction the numerator of which is (i) the aggregate of the denominations of all Certificates of such Class plus, in the case of each Accrual Class, all interest that has accrued on the Certificates of such Class prior to such date of determination and been added to the Class Balance thereof, less (ii) the aggregate amount of all Principal Distribution Amounts, if any, allocable thereto prior to such date of determination and the denominator of which is the original Class Balance of such Class. As to any date of determination and any Interest Only Class, a fraction, the numerator of which is the percentage of the balance specified for such purpose under “Reference Sheet–Notional Classes” in the Prospectus Supplement (or, if applicable, the sum of the applicable percentages of the balances so specified) and the denominator of which is the original Class Balance thereof. Code: The Internal Revenue Code of 1986, as amended, including any successor or amendatory provisions.

  • Note Factor means, with respect to the Notes or any Class of Notes on any Payment Date, a six-digit decimal figure equal to the Note Balance of the Notes or such Class of Notes, as applicable, as of the end of the preceding Collection Period divided by the Note Balance of the Notes or such Class of Notes, as applicable, as of the Closing Date. The Note Factor will be 1.000000 as of the Closing Date; thereafter, the Note Factor will decline to reflect reductions in the Note Balance of the Notes or such Class of Notes, as applicable.

  • Quarterly (1/Quarter) sampling frequency means the sampling shall be done in the months of March, June, August, and December, unless specifically identified otherwise in the Effluent Limitations and Monitoring Requirements table.

  • Unit Price Table means the table of prices per unit set out in the Contract;

  • S&P Volatility Factor means 277% or such other potential dividend rate increase factor as S&P advises the Corporation in writing is applicable.

  • Peak tube potential means the maximum value of the potential difference across the x-ray tube during an exposure.

  • Static water level means the level at which the water stands in the well when the well is not being pumped and is expressed as the distance from a fixed reference point to the water level in the well.

  • Capacity factor means the ratio of the average load on a machine or equipment for the period of time considered to the capacity rating of the machine or equipment.

  • Moody’s Discount Factor means the discount factors set forth in the Moody's Guidelines for use in calculating the Discounted Value of the Fund's assets in connection with Moody's long-term preferred share ratings of the VRDP Shares at the request of the Fund.

  • Floor Level means that stage of construction which in the completed building would constitute the walking surface of the particular floor level referred to in the table of payments.

  • Water table means the upper surface of a zone of saturation, where the body of ground water is not confined by an overlying impermeable zone.

  • Yearly (1/Year) sampling frequency means the sampling shall be done in the month of September, unless specifically identified otherwise in the effluent limitations and monitoring requirements table.

  • Barrier Level means the Barrier Level as specified in § 1 of the Product and Underlying Data.

  • Semi-annual (2/Year) sampling frequency means the sampling shall be done during the months of June and December, unless specifically identified otherwise.

  • Yearly (1/Year) sampling frequency means the sampling shall be done in the month of September, unless specifically identified otherwise in the effluent limitations and monitoring requirements table.