Maximum standard definition

Maximum standard or "MS" means the highest concentration of a toxicant in water to which aquatic organisms can be exposed for a brief time with zero to slight mortality. The MS equals the FAV divided by two. Maximum standards are listed in part 7050.0222.
Sample 1Sample 2Sample 3

Examples of Maximum standard in a sentence

  • Maximum standard uptake value of mediastinal lymph nodes on integrated FDG-PET-CT predicts pathology in patients with non-small cell lung cancer.

  • If the employee must travel in excess of 200 km to attend the funeral, bereavement leave can be extended up to three (3) days.

  • Maximum standard size of drawings shall be metric sheet sizes 594 X 841mm (A1) with standard smaller sizes to be (A4) 210 x 297 mm sheets.

  • Maximum standard dimension ratio (SDR) shall be twenty six (SDR 26).C.

  • It was necessary to purchase this instrument during the Board recess, so that it would be received in time for the fall semester.

  • Height open (standard and HP) = 50.3mm (2.00").• Number of turns open/close - 3.5.• Stainless steel construction.• Maximum standard pressure up to 6,000 psig (414 barg).• Maximum optional pressure up to 10,000 psig (689 barg).

  • NACE compliant materials and oxygen clean are also available along with an extensive list of materials of construction.Specification• Standard seat diameter 4mm.• Optional seat diameter 6mm.• Cv: 0.35 standard.• Maximum standard pressure up to 6,000 psig (414 barg).• Temperature rating -54C to +538C (-65F to +1000F).• Port sizes up to 1/2" pipe thread and 1/2"/12mm tube compression ends as standard.Optional sizes up to 1" pipe, tube and combination ends can be considered.

  • Where n = sample size,N = Total population = 65s = Maximum standard deviation in the population elementsp = proportion of the population elements that belong to the defined categoryi.e. p = 0.5 (95% confidence level)v = standard error of the sampling distribution i.e. v= 0.05 Hence solving for = 0.5(0.5) = 0.25= 0.052 = 0.0025, = = 100 = = 39 The sample size formulae like the one used above, provides the minimum number of responses to be obtained.

  • Transaction charges £50 Maximum standard transaction charge 1% no minimum Transactions with a value below £5,000 £25 Additional charge for transactions in shares Purchases of UK shares are also currently liable to government Stamp Duty at a rate of 0.5% of the consideration.

  • Specifying that DAPNs will apply to “partners or ex-partners who are living together on a permanent, temporary or occasional basis” and the section amended to this effect would not only underline the context of the DAPN, and the housing connection but cover all eventualities where the perpetrator might reside or stay in the home.

Related to Maximum standard

  • Minimum Standards means standards of practice that interpret the legal definition of nursing as well as provide criteria against which violations of the law can be determined.

  • State minimum standards means minimum requirements

  • Uniform standard means a standard adopted by the Commission for a Product line, pursuant to Article VII of this Compact, and shall include all of the Product requirements in aggregate; provided, that each Uniform Standard shall be construed, whether express or implied, to prohibit the use of any inconsistent, misleading or ambiguous provisions in a Product and the form of the Product made available to the public shall not be unfair, inequitable or against public policy as determined by the Commission.

  • Maximum Special Tax means the maximum Special Tax, determined in accordance with Section C below, that can be levied in any Fiscal Year on any Assessor’s Parcel.

  • Baseline Schedule means the initial time schedule prepared by Contractor for Owner’s information and acceptance that conveys Contractor’s and Subcontractors’ activities (including coordination and review activities required in the Contract Documents to be performed by A/E and ODR), durations, and sequence of work related to the entire Project to the extent required by the Contract Documents. The schedule clearly demonstrates the critical path of activities, durations and necessary predecessor conditions that drive the end date of the schedule. The Baseline Schedule shall not exceed the time limit current under the Contract Documents.

  • Maximum State of Charge means the maximum State of Charge that should not be exceeded, measured in units of megawatt-hours. Merchant A.C. Transmission Facilities: “Merchant A.C. Transmission Facility” shall mean Merchant Transmission Facilities that are alternating current (A.C.) transmission facilities, other than those that are Controllable A.C. Merchant Transmission Facilities. Merchant D.C. Transmission Facilities: “Merchant D.C. Transmission Facilities” shall mean direct current (D.C.) transmission facilities that are interconnected with the Transmission System pursuant to Tariff, Part IV and Tariff, Part

  • Service Level Standards has the meaning ascribed thereto in Section 2.1 hereof.

  • Minimum State of Charge means the minimum State of Charge that should be maintained in units of megawatt-hours. NERC:

  • Applicable Standards means the requirements and guidelines of NERC, the Applicable Regional Entity, and the Control Area in which the Customer Facility is electrically located; the PJM Manuals; and Applicable Technical Requirements and Standards.

  • Reliability Standard means a requirement to provide for reliable operation of the bulk power system, including without limiting the foregoing requirements for the operation of existing bulk power system facilities, including cybersecurity protection, and the design of planned additions or modifications to such facilities to the extent necessary for reliable operation of the bulk power system, but shall not include any requirement to enlarge bulk power system facilities or to construct new transmission capacity or generation capacity.

  • Quality Standards means the quality standards published by BSI British Standards, the National Standards Body of the United Kingdom, the International Organisation for Standardisation or other reputable or equivalent body, (and their successor bodies) that a skilled and experienced operator in the same type of industry or business sector as the Contractor would reasonably and ordinarily be expected to comply with, and as may be further detailed in the Specification.

  • Maximum Daily Starts means the maximum number of times that a generating unit can be started in an Operating Day under normal operating conditions.

  • Minimum Hourly Work Requirement means the work hours over a given time period that are required of you by your Employer in order to be eligible for coverage. Your Minimum Hourly Work Requirement is specified in the Schedule of Benefits.

  • Applicable water quality standards means all water quality standards to which a discharge is subject under the federal Clean Water Act and which has been (a) approved or permitted to remain in effect by the Administrator following submission to the Administrator pursuant to Section 303(a) of the Act, or (b) promulgated by the Director pursuant to Section 303(b) or 303(c) of the Act, and standards promulgated under (APCEC) Regulation No. 2, as amended.

  • Design Standards means the standards developed as a requirement of the Programmatic Agreement

  • Maximum Stock Loan Rate As provided in Annex A to this Confirmation.

  • Maximum Limit means that number of issued Shares representing 10% of the total number of issued Shares as at the date of the passing of this Resolution (excluding any Shares which are held as treasury shares as at that date); and

  • Maximum Weekly Starts means the maximum number of times that a generating unit can be started in one week, defined as the 168 hour period starting Monday 0001 hour, under normal operating conditions. Member:

  • Maximum Legal Rate means the maximum nonusurious interest rate, if any, that at any time or from time to time may be contracted for, taken, reserved, charged or received on the indebtedness evidenced by the Note and as provided for herein or the other Loan Documents, under the laws of such state or states whose laws are held by any court of competent jurisdiction to govern the interest rate provisions of the Loan.

  • Maximum Daily Limit means the maximum allowable "Daily Concentration" (defined above) when expressed as a concentration (e.g. mg/l), otherwise, it means the maximum allowable "Daily Quantity" as defined above, unless it is expressed as a flow quantity. If expressed as a flow quantity it means "Maximum Daily Flow" as defined in Section 22a-430-3(a) of the RCSA.

  • Final Level means, in respect of the Index, the Closing Level on the Final Valuation Date, provided that, if the Final Valuation Date is not an Exchange Business Day, then the Final Level will be determined on the immediately preceding

  • Minimum Essential Coverage has the meaning given in the Affordable Care Act, 26 U.S.C. §5000A(f).

  • Minimum Weighted Average Coupon Test means a test that will be satisfied on any Measurement Date if the Weighted Average Coupon equals or exceeds 7.0%.

  • Design Criteria means design and construction code requirements relating to the mode of design and construction of a boiler or pressure vessel.

  • Maximum Net Mortgage Rate As to any Mortgage Loan and any date of determination, the Maximum Mortgage Rate for such Mortgage Loan minus the per annum rate at which the Servicing Fee is calculated.

  • Point of compliance means the location(s) at the source(s) of contamination or at the location(s) between the source(s) and the point(s) of exposure where concentrations of chemicals of concern must meet applicable risk-based screening levels at Tier 1 or other target level(s) at Tier 2 or Tier 3.