Maximum allowable operating pressure definition

Maximum allowable operating pressure means the maximum pressure at which a pipeline or segment of a pipeline may be operated under 49 C.F.R. 192 as was effective on February 18, 2014.
Sample 1Sample 2Sample 3
Maximum allowable operating pressure or “MAOP” means the maximum pressure at which the Gathering System can operate under normal operating conditions.
Sample 1Sample 2Sample 3
Maximum allowable operating pressure means the maximum pressure at which a pipeline or a segment of pipeline may be operated under this Part.
Sample 1Sample 2Sample 3

Examples of Maximum allowable operating pressure in a sentence

  • Maximum allowable operating pressure for which the line is being constructed.

  • As two examples, El Salvador reports production of most crops in terms of quintals, and the United States of America reports production for most grain crops in terms of bushels.

  • INGAA requests PHMSA modify § 192.624(c)(3) consistent with the suggested regulation text below.138§ 192.624 Maximum allowable operating pressure verification: Onshore steel transmission pipelines.

  • PSC 135.621 (1) is amended to read: PSC 135.621 Maximum allowable operating pressure: high-pressure distribution systems additions [49 CFR 192.621].(1) After 49 CFR 192.621 (a) (3), insert:(3w) No person may operate a segment of a cast iron pipe in which there are unreinforced bell and spigot joints at a pressure higher than low pressure unless it can be proven to the commission that they can be operated at a higher pressure.

  • In § 192.619, revise paragraph (a)(3) and paragraph (c) to read as follows:§ 192.619 Maximum allowable operating pressure: Steel or plastic pipelines.(a) * * * (3) The highest actual operating pressure to which the segment was subjected during the 5 years preceding the applicable date in the second column.

  • Asheville, NC: U.S. Department of Agriculture, Forest Service, Southeastern Forest Experiment Station: 75-83.

  • Subject to the agreement of the ERO, ballot information can be sent electronically to members who have provided an e-mail address, and by post to those who have no e-mail address or have expressed a preference for postal ballot information.

  • Acrylic latex for exterior use from manufacturer specified in 2.01 A.

  • Section 192.624 is added to read as follows: § 192.624 Maximum allowable operating pressure reconfirmation: Onshore steel transmission pipelines.

  • Amend § 192.619 by revising paragraph (a) introductory text and by adding paragraph (d) to read as follows: § 192.619 Maximum allowable operating pressure: Steel or plastic pipelines.


More Definitions of Maximum allowable operating pressure

Maximum allowable operating pressure. (“MAOP”) shall mean the maximum
Sample 1Sample 2
Maximum allowable operating pressure means the maximum pressure authorized by the department and measured at the product side of the wellhead.
Sample 1
Maximum allowable operating pressure means the maximum pressure authorized by the di- rector and measured at the wellhead.
Sample 1
Maximum allowable operating pressure or “MAOP” means the maximum pressure at which the System may be operated which, unless otherwise communicated in writing by Gatherer to Shipper, shall be 1440 psig.
Sample 1
Maximum allowable operating pressure means the maximum pressure at which a pipeline or segment of a pipeline may be operated under these Regulations;
Sample 1Sample 2
Maximum allowable operating pressure or “MAOP” means the maximum pressure of the regulated substance at which an underground storage cavern system is capable of maintaining its mechanical integrity. The maximum allowable operating pressure of any system is the test pressure minus the safety margin.
Sample 1

Related to Maximum allowable operating pressure

  • Maximum allowable cost means the maximum amount that a pharmacy benefit manager will reimburse a pharmacy for the cost of a drug.

  • Maximum allowable cost list means a list of drugs for

  • Maximum Applied Water Allowance (MAWA) means the upper limit of annual applied water for the established landscaped area as specified in Section 492.4. It is based upon the area's reference evapotranspiration, the ET Adjustment Factor, and the size of the landscape area. The Estimated Total Water Use shall not exceed the Maximum Applied Water Allowance. Special Landscape Areas, including recreation areas, areas permanently and solely dedicated to edible plants such as orchards and vegetable gardens, and areas irrigated with recycled water are subject to the MAWA with an ETAF not to exceed 1.0. MAWA = (ETo) (0.62) [(ETAF x LA) + ((1-ETAF) x SLA)]

  • Baseline area means any intra- state area (and every part thereof) des- ignated as attainment or unclassifiable under section 107(d)(1)(A)(ii) or (iii) of the Act in which the major source or major modification establishing the minor source baseline date would con- struct or would have an air quality im- pact for the pollutant for which the baseline date is established, as follows: equal to or greater than 1 μg/m3 (an- nual average) for SO2, NO2, or PM10; or equal or greater than 0.3 μg/m3 (annual average) for PM2.5.(ii) Area redesignations under section 107(d)(1)(A)(ii) or (iii) of the Act cannot intersect or be smaller than the area of impact of any major stationary source or major modification which:

  • Finished water means the water that is introduced into the distribution system of a public water system and is intended for distribution and consumption without further treatment, except as treatment necessary to maintain water quality in the distribution system (e.g., booster disinfection, addition of corrosion control chemicals).

  • Building Square Footage or "BSF" means the square footage of assessable internal living space of a Unit, exclusive of any carports, walkways, garages, overhangs, patios, enclosed patios, detached accessory structure, other structures not used as living space, or any other square footage excluded under Government Code Section 65995 as determined by reference to the Building Permit for such Unit.

  • The Contract Price/ Project Cost means the price payable to the Vendor under the Contract for the full and proper performance of its contractual obligations.

  • Water Year means the period commencing with October 1 of 1 year 20 and extending through September 30 of the next; and

  • Gross weight means the aggregate weight of a vehicle or combination of vehicles and the load

  • Total Operating Expenses means all costs and expenses paid or incurred by the Company, as determined under generally accepted accounting principles, that are in any way related to the operation of the Company or to Company business, including advisory fees, but excluding (i) the expenses of raising capital such as Organization and Offering Expenses, legal, audit, accounting, underwriting, brokerage, listing, registration, and other fees, printing and other such expenses and tax incurred in connection with the issuance, distribution, transfer, registration and Listing of the Shares, (ii) interest payments, (iii) taxes, (iv) non-cash expenditures such as depreciation, amortization and bad debt reserves, (v) incentive fees paid in compliance with the NASAA REIT Guidelines, (vi) Acquisition Fees and Acquisition Expenses, (vii) real estate commissions on the Sale of Properties, (viii) Financing Coordination Fees and (ix) other fees and expenses connected with the acquisition, disposition, management and ownership of real estate interests, mortgage loans or other property (including the costs of foreclosure, insurance premiums, legal services, maintenance, repair and improvement of property).

  • Total Contract Price/Project Cost/TCO means the price payable to Service Provider over the entire period of Contract for the full and proper performance of its contractual obligations.