Low Battery definition

Low Battery. The battery capacity is low and cannot support the connected computers if they require a shutdown.  Alarm: The UPS is issuing an audible alarm due to a warning event, such as Overload  Bypass: The UPS has switched to bypass mode due to an overload or UPS fault.  UPS Fault: The UPS may be malfunctioning due to an internal problem, such as an inverter fault, bus fault or overheating.  Redundant Quantity: Sets the quantity of UPS modules to be power redundancy. This power redundancy can provide the fault-tolerant protection against failures of equivalent UPS modules. UPS should avoid exceeding output load from whom deducted the power redundancy; otherwise UPS cannot afford the equivalent fault-tolerant protection as user’s desire.
View Source

Examples of Low Battery in a sentence

  • If this is due to an overly discharged battery of the correct voltage, the F3 indication can be manually overridden by pressing the I/O button while the F3 message (Low Battery) displays.

  • If this is due to an overly discharged battery of the correct voltage, the F3 indication can be manually overridden by pressing STOP while the F3 message (Low Battery) displays.

  • If you return the EV at a lower charge rate than the battery departure level: - You will be charged the EV Battery Recharging Service fee to bring the EV back up to the battery departure level; and - If you return the vehicle at less than 10% battery level, an additional Low Battery Recharging Service fee (equivalent to one day rental) will be applied *Any applicable charges will be processed on the card provided.

  • The decimal values of different point types are: - The Input Register/AI Object alarms ▪ “0” = Normal ▪ “1” = Low Battery Alarm (Bit 1 set) ▪ “2” = Lost Communication Alarm (Bit 2 set) - The Digital Output (Coil) Registers/BV Object alarm (Not used) ▪ “0” = Normal - The Analog Output (Holding) Registers/AV Object alarm (Not used) ▪ “0” = Normal Alarm Status Examples: - Example 1 – AI108 returns a value of 1 representing AI08 (Low Battery Alarm).

  • These six sites include the following: the Low Battery Wall near the terminus of ▇▇▇▇▇▇ Blvd., the High Battery Wall near the terminus of E.

  • Periodic Low Battery Check The low battery periodic check is based upon the selected value .Valid selections are: None and from 1hr to 15 hrs (in hourly increments).

  • Manual Alert Reset Low Battery Alert Key Click With this option selected and the pager in the audible mode, an incoming message alert can only be stopped manually by pressing any button on the pager.

  • The following additional keypad functions are available: Press STOP whiles the F3 message (Low Battery) displays.

  • Wait Signal A Supervisory, Trouble, AC Power Failure or Low Battery may only be held for up to the following periods waiting for a Restore Signal.

  • Periodic Low Battery Check The low battery periodic check is based upon the selected value.