IP Control definition
Examples of IP Control in a sentence
DYPM shall dispatch such Supply Resources as required by this Agreement in the manner required to support compliance with applicable requirements and guidelines of NERC, MAIN, any other regional reliability council of which the IP System or IP Control Area is a member, and the MISO.
For the term of this Agreement, (y) IP shall not request, without the prior written consent of DYPM, that MISO separate the IP Control Area into more than one load zone; and (z) DYPM shall not request, without the prior written consent of IP, that MISO separate the IP Control Area into more than one load zone.
In the event DYPM fails promptly to procure and/or dispatch such additional Supply Resources as required in the foregoing sentence, IP shall take reasonable actions, consistent with Good Utility Practice, to maintain the balance of electric supply and electric load on the IP System and in the IP Control Area, including obtaining additional Energy, and/or Ancillary Services as necessary to balance electric supply and electric load on the IP System and in the IP Control Area.
Following such Change of Control and/or NxStage IP Control Change, such Main Set Commitment shall only apply to NxStage Main Sets incorporating NxStage Intellectual Property and shall not apply to other Main Sets then made, or subsequently made, by such successor, assignee or new owner of such sufficient NxStage Intellectual Property.
There are up to 24 Traffic Control (TC) modules at the IP Control Point, one module for each RF frequency (channel) in the simulcast system.
The proposed system is capable of supporting 24 RF channels and doesn’t use a typical voting comparator but uses the MASTR V IP Control Point Traffic Controller Module within the Simulcast Control Point to perform voting functions that a voting comparator would perform.
Except as provided in Section 7(e), WESCO shall control the level of generation of the Units based on information provided by IP for purposes of ensuring reliability and balance of aggregate load and generation within the IP System and the IP Control Area, subject to any hourly or annual limits on WESCO’s obligation to supply capacity and energy pursuant to this Agreement.
WESCO shall Dispatch the Units in the manner required to support compliance with applicable requirements and guidelines of NERC, MAIN, any other regional reliability council of which the IP System or IP Control Area is a member, and the Independent System operator, and, subject to the foregoing requirements.
The Simulcast IP Control Point and NSC alarms are sent to the Network Sentry which in turn report to the RNM.
Figure 2 is a high-level block diagram for the P25IP GPS Simulcast IP Control Point and transmit site.