Grade Copper Cathode definition

Grade Copper Cathode means copper cathode conforming to the specifications (as to chemical and physical requirements) for Grade A Copper conforming to BS EN 1978:1998 (Cu- CATH-1) or any successor thereto, as revised from time to time.

Examples of Grade Copper Cathode in a sentence

  • During the term of this Agreement, the price of Wire will be adjusted on the 1st of each month to reflect the prior month's spot COMEX average cost per pound of High Grade Copper Cathode.

Related to Grade Copper Cathode

  • Copper Loop is a stand-alone local loop comprised entirely of copper wire or cable. Copper Loops include two-wire and four-wire analog voice-grade copper Loops, digital copper Loops (e.g., DS0s and integrated services digital network lines), as well as two-wire and four-wire copper Loops conditioned to transmit the digital signals needed to provide digital subscriber line services, regardless of whether the copper Loops are in service or held as spares. The copper Loop includes attached electronics using time division multiplexing technology, but does not include packet switching capabilities.

  • Ethanol blended gasoline means the same as defined in section 214A.1.

  • Diameter at Breast Height (DBH) means the diameter of the trunk of a mature tree generally measured at a point four and a half feet above ground level from the uphill side of the tree. For species of trees where the main trunk divides below the 4 ½ foot height, the DBH shall be measured at the highest point before any division.

  • heat pump means a machine, a device or installation that transfers heat from natural surroundings such as air, water or ground to buildings or industrial applications by reversing the natural flow of heat such that it flows from a lower to a higher temperature. For reversible heat pumps, it may also move heat from the building to the natural surroundings;

  • Double check valve assembly means an assembly composed of two single, independently acting, check valves including tightly closing shutoff valves located at each end of the assembly and suitable connections for testing the watertightness of each check valve.