Factory Default definition

Factory Default means the numeric value after the function code parameter is refreshed when recovering the default parameter, but the actually measured value or recorded value will not be refreshed.
View Source

Examples of Factory Default in a sentence

  • At the end of the program, the ICT Department will reset the laptop back to Factory Default removing all the software loaded onto the laptop by the College.

  • Restoring to the Factory Default Settings with the RESET Switch on the Camera‌‌ If the IP address or the Administrator password on the camera is forgotten, operating the camera via the network is not possible.

  • If the server system has any problem and needs to be re-initialized, please enter WorldCard Team Server desktop, and click [Settings] , then click [Factory Default] on the left side of the screen, and then click [Apply] button to start initialization.

  • The Factory Default option allows you to reset system settings to the factory default.

  • Turn on power, and the Transceiver can be communicated with using the Factory Default IP Address 192.168.0.1 Subnet Mask 255.255.255.0. The Config File is no longer active while the jumper is in the “Init” position.

  • Turn on power and the Transceiver can be communicated with using the Factory Default IP Address 192.168.0.1 Subnet Mask 255.255.255.0. The Config File is no longer active while the jumper is in the “Init” position .

  • Timeout Off 10 sec.* Timeout (1-60) 10 sec.* Report Status (1-60) Disable* Report Status Enable Disable* Enable (from page 54) * = Factory Default 1 Available when an Ethernet Adapter is present.

  • Turn on power and the Gateway can be communicated with using the Factory Default IP Address 192.168.0.1 Subnet Mask 255.255.255.0. The Config File is no longer active while the jumper is in the “Init” position.

  • Page 8 CLI Properties Display Commands 3-7 Chapter 4: System Configuration Factory Default Settings ..........................4-1 Initial Configuration Overview .........................

  • Centronics (Parallel)‌ Data Bit 8 (from page 54) * = Factory Default Enable* Disable Enable* Disable Standard* Standard* Inverted Inverted Enable* Disable Leading* Trailing Buffer Size In K TOF Action Prime Signal Latch Data On Busy On Strobe Resp.