DIP switch definition

DIP switch means one of a set of small on-off switches mounted inside a self-contained lighting control that modifies the functionality of the lighting control.

Examples of DIP switch in a sentence

  • A dot flashing on the LED indicates it is operating normally.2. Note the position of each switch on the DIP switch.

  • To turn a DIP switch on, push the switch toward the battery pack.

  • DIP switch configurations are always listed in the product's datasheet.

  • For parameters set using the DIP switches, the DIP switch positions override any changes made using the configuration software.Access the Internal DIP SwitchesFollow these steps to access the internal DIP switches.1. Unscrew the four screws that mount the cover to the bottom housing.2. Remove the cover from the housing without damaging the ribbon cable or the pins the cable plugs into.3. Gently unplug the ribbon cable from the board mounted into the bottom housing.

  • Install your wireless sensor network components.Configure the DIP SwitchesBefore changing DIP switch positions, disconnect the power.

  • This DIP switch is used only on the 0 to 20 mA models, not the 0 to 10V models.

  • This feature can be disabled via a DIP switch on the device keypad.

  • Modules requiring EPROM, PROM, ROM changes or DIP switch and/or jumper changes shall not be acceptable.

  • The monitor module shall provide address-setting means using a binary DIP switch.

  • If the installation instructions are not included in this datasheet, refer to the product manual.For additional information, refer to one of the following documents:• MultiHop Data Radio Quick Start Guide: 152653• MultiHop Data Radio Instruction Manual: 151317• MultiHop Register Guide: 155289Configure the DIP SwitchesBefore changing DIP switch positions, disconnect the power.

Related to DIP switch

  • Dead-man switch means a switch so constructed that a circuit closing contact can be maintained only by continuous pressure on the switch by the operator.

  • Packet Switch is a router designed to read the destination address in an incoming cell or packet, consult a routing table and route the packet toward its destination. Packetizing is done in originating CPE and reassembly is done in terminating CPE. Multiple packet formats or protocols exist (e.g., x.25, x.75, frame relay, ATM, and IP).

  • End Office Switches (“EOs”) are switches from which end user Telephone Exchange Services are directly connected and offered.

  • Access Tandem Switch is a Switch used to connect End Office Switches to interexchange Carrier Switches. Qwest's Access Tandem Switches are also used to connect and switch traffic between and among Central Office Switches within the same LATA and may be used for the exchange of local traffic.

  • End Office Switch or “End Office” means the switching machine that directly terminates traffic to and receives traffic from purchasers of local Exchange Services. An End Office Switch does not include a PBX.

  • Local Tandem Switch is a CenturyLink switch used to connect and switch trunk circuits between End Office Switches for traffic within an EAS/Local calling area.

  • Switch means a switching device employed by a Carrier within the Public Switched Network. Switch includes but is not limited to End Office Switches, Tandem Switches, Access Tandem Switches, Remote Switching Modules, and Packet Switches. Switches may be employed as a combination of End Office/Tandem Switches. "Switched Access Service" means the offering of transmission and switching services to Interexchange Carriers for the purpose of the origination or termination of telephone toll service. Switched Access Services include: Feature Group A, Feature Group B, Feature Group D, 8XX access, and 900 access and their successors or similar Switched Access Services. "Switched Access Traffic" is traffic that originates at one of the Party's End User Customers and terminates at an IXC Point of Presence, or originates at an IXC Point of Presence and terminates at one of the Party's End User Customers, whether or not the traffic transits the other Party's network.

  • Adult motion picture theater means a commercial establishment where, for any form of consideration, films, motion pictures, video cassettes, slides, or similar photographic reproductions are regularly shown which are characterized by the depiction or description of "specified sexual activities" or "specified anatomical areas."

  • Freight Switcher means a locomotive that moves rail cars around a rail yard as compared to a line-haul engine that moves freight long distances.

  • Drum means any cylindrical metal shipping container of 13 to 110 gallon capacity.

  • Tandem Office Switch or “Tandem(s)” are used to connect and switch trunk circuits between and among other Central Office Switches. A Tandem Switch does not include a PBX.

  • Trunk means a communication line between two switching systems.

  • Exhaust emissions means the emission of gaseous, solid and liquid compounds from the tailpipe.

  • DIP Claims means, collectively, the DIP ABL Claims and the DIP Term Loan Claims.

  • IntraLATA LEC Toll means IntraLATA Toll traffic carried solely by a Local Exchange Carrier and not by an IXC. "IntraLATA Toll Traffic" describes IntraLATA Traffic outside the Local Calling Area.

  • Transmission License means the license granted by the Appropriate Commission in terms of the relevant regulations for grant of such license issued under The Electricity Act, 2003;

  • Superpriority Claim means a claim against the Borrower and any Guarantor in any of the Cases which is an administrative expense claim having priority over any or all administrative expenses of the kind specified in Sections 503(b) or 507(b) of the Bankruptcy Code.

  • Customer-generator means a user of a net metering system.

  • Trunk Line means the coaxial/optic fiber cable network and other allied equipment such as receiver nodes, amplifiers, splitters etc. owned and installed by the multi-system operator or its associate companies for the purpose of transmitting Cable TV Signal to various LCOs till the receiving end of various LCOs, including the LCO, to enable them to re-transmit the Cable TV Signal to respective subscribers; All other words and expressions used in this interconnection agreement but not defined, and defined in the Act and rules and regulations made thereunder or the CTN Act and the rules and regulations made thereunder, shall have the meanings respectively assigned to them in those Acts or the rules or regulations, as the case may be.

  • Pupil Generated Content The term “pupil-generated content” means materials or content created by a pupil during and for the purpose of education including, but not limited to, essays, research reports, portfolios, creative writing, music or other audio files, photographs, videos, and account information that enables ongoing ownership of pupil content.

  • Transmission Licensee means a licensee authorised to establish or operate transmission lines;

  • PNode has the meaning set forth in the CAISO Tariff.

  • Loader means any type of off-road tractor with either tracks or rubber tires that uses a bucket on the end of movable arms to lift and move material; can be also referred to as a front-end loader, front loader, skid steer loader, backhoe, rubber- tired loader, or wheeled loader.

  • Shared Transport is defined as local interoffice transmission facilities shared by more than one Carrier, including Qwest, between End Office Switches, between End Office Switches and Tandem Switches (local and Access Tandem Switches), and between Tandem Switches within the Local Calling Area, as described more fully in the Agreement.

  • Service Switching Point (SSP means the telephone Central Office Switch equipped with a Signaling System 7 (SS7) interface.

  • Autocycle means the same as that term is defined in Section 53-3-102.