Examples of Boom assembly in a sentence
Place the Mast with Boom assembly upright in the tube on the Base assembly as shown in Figure 2.
Following assembly and clean certification, when the Boom assembly is transported outside of a clean environment, the unit will be double-bagged with Llumalloy (anti-static) bagging material .
PREPARING FOR A LIFT — Boom assembly and disassembly, reasons to repair/scrap boom sections, Wire rope installation, reeving, wedge sockets, telescoping booms, setting-up, measuring radius, radius over boom angle, outrigger set-up, block outriggers, leveling methods.
To verify all Boom components are non-magnetic, a ‘Magnetics Cleanliness’ test shall be performed at UCB during and following all Boom assembly activities.
Any bridge or tunnel to be constructed under this Order for carrying a highway over or under a tramroad shall be constructed in accordance with plans and specifications approved by the highway authority, but such approval shall not be unreasonably withheld.
Top level assembly 14Figure 6, Boom assembly 14Figure 7, First boom assembly 16Figure 8, Second boom assembly 17Figure 9, Third boom assembly 18Figure 10, Frame assembly 192 OverviewThe Spida Truss Stacker is designed to transport timber wall frame assemblies from the conveyor systems and stack the frames on a packing or wrapping station ready to be transported to a job site.The Wall Stacker must be used per the standard operating procedures set out in this manual.
Boom assembly must consist of a main/jib boom combination of approximately 25’ with wristing action located on jib boom.
Place the Mast with Boom assembly upright in the tube on the Base assembly as shown in Figure 4.
Install Boom assembly on to Debris stack (No hardware required) Step 1: Slide boom up into top mount position Step 2: Slide bottom of boom into lower mount position Important Note: Don’t Stand on Unit.
Boom assembly shall be insulated meeting ANSI 92.2-2015 Category C standards at minimum.