Backward definition

Backward buttons for trolley.
Sample 1Sample 2
Backward means that rays are emitted from the radiative surfaces. Each solar radiation source produces one ray that follows the directional vector backward. After it reaches the outer boundary or the surface having appropriate radiation boundary condition, the exchange factor can be estimated as: (2-71)The ISk is the solar radiation intensity of the k-th solar source. The value δki equals 1 if the i-th cluster is visible for the k-th solar source, and 0 if not.
Sample 1Sample 2
Backward means shy in Northern Ireland.
Sample 1

Examples of Backward in a sentence

  • Scheduled Castes, Scheduled Tribes and Other Backward Classes Certificates should be in accordance with the instructions of the Govt.

  • Administrator/Secretary to Administrator/Development Officer(Lakshadweep) Proforma-II The form of certificate to be produced by Other Backward Classes candidates applying for appointment to posts under the Government of India.

  • Varala included vide G.O. Ms.No. 12 Backward Classes Welfare (C2) Dept., dt.

  • Poosala included vide G.O. Ms.No. 16 Backward Classes Welfare (C2) Dept., dt.

  • Atirasa included vide G.O. Ms.No. 5 Backward Classes Welfare (C2) Dept., dt.

  • Sondi / Sundi included vide G.O. Ms.No. 11 Backward Classes Welfare (C2) Dept., dt.

  • Keuta/Kevuto/Keviti, included vide G.O. Ms. No. 15, Backward Classes Welfare (C2) Dept., Dt. 27/05/2011.

  • As far as block allocation in Block-A and Block-B of Backward Classes category is concerned, year-wise rotational system will be adopted.

  • Siddula, Included vide G.O.Ms.No. 9 Backward Classes Welfare (C2) Dept., dt.

  • Gotrala, Included vide G.O.Ms.No. 7 Backward Classes Welfare (C2) Dept., dt.


More Definitions of Backward

Backward means taking defined acceptable risk levels at points of exposure, and back- calculating soil contaminant levels which would achieve that level of risk.
Sample 1
Backward means you begin the valuation process at expiration and move backward through the tree to the starting date; "recursion" means you use the same formula over and over again at every step.
Sample 1

Related to Backward

  • compatibility means compatibility as defined in point (10) of Article 2 of Directive (EU) 2019/770;

  • Uptime means the time period when specified services are available with specified technical and service standards as mentioned in section titled WARRANTY SUPPORT” "%Uptime" means ratio of 'up time' (in minutes) as mentioned in section titled “Warranty support”

  • Outputs means the goods or services that are produced by an entity or other person;

  • Packet Switch is a router designed to read the destination address in an incoming cell or packet, consult a routing table and route the packet toward its destination. Packetizing is done in originating CPE and reassembly is done in terminating CPE. Multiple packet formats or protocols exist (e.g., x.25, x.75, frame relay, ATM, and IP).

  • Spectrum Compatibility means the capability of two (2) copper loop transmission system technologies to coexist in the same cable without service degradation and to operate satisfactorily in the presence of cross talk noise from each other. Spectrum compatibility is defined on a per twisted pair basis for specific well-defined transmission systems. For the purposes of issues regarding Spectrum Compatibility, service degradation means the failure to meet the Bit Error Ratio (BER) and Signal-to-Noise Ratio (SNR) margin requirements defined for the specific transmission system for all Loop lengths, model Loops, or loss values within the requirements for the specific transmission system.

  • Ethernet means a family of computer networking technologies for LANs.

  • Synchronous means instruction delivered by the virtual education teacher and received by the student concurrent in time;

  • Switch means a switching device employed by a Carrier within the Public Switched Network. Switch includes but is not limited to End Office Switches, Tandem Switches, Access Tandem Switches, Remote Switching Modules, and Packet Switches. Switches may be employed as a combination of End Office/Tandem Switches. "Switched Access Service" means the offering of transmission and switching services to Interexchange Carriers for the purpose of the origination or termination of telephone toll service. Switched Access Services include: Feature Group A, Feature Group B, Feature Group D, 8XX access, and 900 access and their successors or similar Switched Access Services. "Switched Access Traffic" is traffic that originates at one of the Party's End User Customers and terminates at an IXC Point of Presence, or originates at an IXC Point of Presence and terminates at one of the Party's End User Customers, whether or not the traffic transits the other Party's network.

  • SDSL or "Symmetric Digital Subscriber Line" is a baseband DSL transmission technology that permits the bi-directional transmission from up to 160 kbps to 2.048 Mbps on a single pair. "VDSL" or "Very High Speed Digital Subscriber Line" is a baseband DSL transmission technology that permits the transmission of up to 52 Mbps downstream (from the Central Office to the End User Customer) and up to 2.3 Mbps digital signal upstream (from the End User Customer to the Central Office). VDSL can also be 26 Mbps symmetrical, or other combination.

  • Bandwidth means a distributor’s defined tolerance used to flag data for further scrutiny at the stage in the VEE process where a current reading is compared to a reading from an equivalent historical billing period. For example, a 30 percent bandwidth means a current reading that is either 30 percent lower or 30 percent higher than the measurement from an equivalent historical billing period will be identified by the VEE process as requiring further scrutiny and verification;

  • IVR means Interactive Voice Response.

  • SPID is the number that identifies a service provider to the relevant NPAC. The SPID may be a state-specific number. "Serving Wire Center" denotes the CenturyLink building from which dial tone for local Exchange Service would normally be provided to a particular End User Customer premises. "Signaling System 7" or "SS7" is an out-of-band signaling protocol consisting of four basic sub- protocols:

  • Trap means fixed gear anchored to the bottom, usually containing a guide net that leads bluefin tuna into an enclosure or series of enclosures where it is kept prior to harvesting or farming;

  • Signal means any transmission of radio frequency energy or of optical information.

  • Process weight means the total weight of all materials introduced into any source operation. Solid fuels charged will be considered as part of the process weight, but liquid and gaseous fuels and combustion air will not.

  • Latency means the additional time, beyond that of the basic perceivable response time of the aircraft due to the response time of the FSTD.

  • Interoperability means the ability of a CenturyLink OSS Function to process seamlessly (i.e., without any manual intervention) business transactions with CLEC's OSS application, and vice versa, by means of secure exchange of transaction data models that use data fields and usage rules that can be received and processed by the other Party to achieve the intended OSS Function and related response. (See also Electronic Bonding.)

  • Module means specific portion of the Application Software designated as such in the Documentation made available to the Customer under the Notification Form.

  • High-temperature coating means a high performance coating labeled and formulated for application to substrates exposed continuously or intermittently to temperatures above 204oC (400oF).

  • Output means the exposure rate, dose rate, or a quantity related in a known manner to these rates from a brachytherapy source or a teletherapy, remote afterloader, or gamma stereotactic radiosurgery unit for a specified set of exposure conditions.

  • Spacecraft (7 9) means active and passive satellites and space probes.

  • Dataset means the data specified in Appendix 1 (Environmental Information) to Schedule 11.2 (Management Information) as the same may be amended from time to time by the Secretary of State (acting reasonably);

  • functionality means the ability of a tenderer to provide goods or services in accordance with specifications as set out in the tender documents.

  • ADSL or "Asymmetric Digital Subscriber Line" is a Passband digital loop transmission technology that typically permits the transmission of up to 8 Mbps downstream (from the Central Office to the End User Customer) and up to 1 Mbps digital signal upstream (from the End User Customer to the Central Office) over one (1) copper pair. "HDSL" or "High-Data Rate Digital Subscriber Line" is a synchronous baseband DSL technology operating over one or more copper pairs. HDSL can offer 784 Kbps circuits over a single copper pair, T1 service over two (2) copper pairs, or future E1 service over three (3) copper pairs. "HDSL2" or "High-Data Rate Digital Subscriber Line 2" is a synchronous baseband DSL technology operating over a single pair capable of transporting a bit rate of 1.544 Mbps.

  • Network Upgrades means modifications or additions to transmission-related facilities that are integrated with and support the Transmission Provider’s overall Transmission System for the general benefit of all users of such Transmission System. Network Upgrades shall include:

  • Backflow means the backflow of water or other liquids, mixtures, or substances into the distribution pipes of a potable water system from any source other than the intended source of the potable water supply.