Examples of ASME Code A17.1 in a sentence
Each service shall meet the following minimum requirements:• The Services sha l l meet ASME Code A 17.1-2007/CSA B44-07, ASME Code A 17.3-2002, ASME Code A 18.1-2005, and ASCE Code 21 as required by the Texas Department of Licensing and Regulation or equivalent for the state(s) of respondent(s)’ territory.• Section 8.6 of the ASME Code A17.1 specifically addresses the requirements for a comprehensive maintenance program.
The wood blocking shall be located in all walls adjacent to a toilet, shower stall or bathtub.
The term does not include maintenance, repair, replacement, or a cosmetic change that does not affect the operational safety of the equipment or diminish the safety of the equipment below the level required by the ASME Code A17.1, ASME Code A17.3, ASME Code A18.1, or ASCE Code 21, as applicable, at the time of alteration.
Standards adopted under [by the] commission rules may not contain requirements in addition to the requirements in the ASME Code A17.1, ASME Code A17.3, ASME Code A18.1, or ASCE Code 21.
The executive director may [shall] grant a delay for compliance with the codes and adopted standards [applicable ASME Code A17.1, ASME Code A17.3, or ASME Code A18.1] until a specified time if the executive director determines that the noncompliance does not constitute a significant threat to passenger or worker safety [compliance is not readily achievable, as that phrase is defined in the Americans with Disabilities Act (42 U.S.C. Section 12101 et seq.), or regulations adopted under that Act].
The building shall not be occupied until such buildings or enclosures have been constructed.
Elevators, chairlifts, or platform lifts installed in a single-family dwelling on or after January 1, 2004, must comply with the ASME Code A17.1 or A18.1, as applicable, and must be inspected by a registered elevator inspector after the installation is complete.
Elevators, chairlifts, or platform lifts installed in a single-family dwelling on or after January 1, 2004, must comply with the ASME Code A17.1 or A18.1, as applicable, and must be inspected by a registered elevator [QEI-1 certified] inspector after the installation is complete.
Standards adopted under commission rules may not contain requirements in addition to the requirements in the ASME Code A17.1, ASME Code A17.3, ASME Code A18.1, or ASCE Code 21.
Standards adopted under [by the] commission rules must require equipment to comply with the installation requirements of the ASME Code A17.1, ASME Code A18.1, or ASCE Code 21 that was in effect and applicable on the date of installation of the equipment.