User note. The above preamble generally applies for works in hot and humid coastal areas Face bricks Bricks shall be ordered timeously to obtain uniformity in size and colour Carried Forward R Section No. 2 Bill No. 3 MASONRY Amount Brought Forward R Pointing Descriptions of recessed pointing to fair face brickwork and face brickwork shall be deemed to include square recessed, hollow recessed, weathered pointing, etc BLOCKWORK Concrete masonry units Blocks are to be either solid or hollow modular dense concrete masonry units having a compressive strength of 7 MPa Wall ties for blockwork Wall ties shall be polypropylene "Permaties" complying with BS 76377. Ties for hollow walls shall be of sufficient length to allow not less than 75mm of each end to be built into the blockwork. Ties are to be spaced at intervals of not more than 1m in the horizontal direction and not more than 400mm staggered in the vertical direction except at openings, vertical joints or ends of walls where they are to be placed vertically above each other Blockwork shall comply with SABS 0145 "Concrete Masonry Construction"
User note. If the rolling forecasts are provided on a monthly basis, it may make sense to provide the same deadline here as that for the Distributor’s monthly reports to be provided in accordance with clause 7.5.]
User note. When using the following system of measuring cupboard fittings a detailed specification must either be incorporated on the detail drawings of the cupboards or included here
User note. The above preamble generally applies for works in hot and humid coastal areas Face bricks Bricks shall be ordered timeously to obtain uniformity in size and colour Carried Forward R Section No. 6 Bill No. 3 MASONRY
User note. It is important that this section set out a clear and comprehensive description of the Services to be provided by the Provider. To the extent that any tender documentation for the funding included a scope of services and service specifications these should also be included or referenced in this section. In particular, this section should: (a) contain all of the Agency's requirements and purposes for the Services; (b) be drafted to provide clear objective benchmarks for the Services against which the Provider's performance of the Services can be assessed; (c) if the Services are to be provided in stages, clearly indicate what those stages are and what is required to be carried out by the Provider in each stage; (d) if the section below will specify a Target Group(s) for whom the Services are to be provided then the scope of services relating to each such group should be separately described; and (e) if the Services are to be provided during any specific period(s) then this should be specified (e.g. by specifying the start and end date)] Target Group (Clauses 1.1 and 5.1(a)(i)) [#Insert any applicable Target Group for whom the Services must be provided. If no Target Group will apply, then insert the words "Not applicable"] Objectives (Clauses 1.1 and 5.1(a)(v)) [#Insert the Agency's objectives for the Services] Funds and payment (Clauses 1.1 and 9.1)
