STANDARDS AND TYPES Sample Clauses

STANDARDS AND TYPES. 7.1. Standards: All gypsum board shall be standard 5/8” material, unless otherwise required by code (i.e.: MR board @ restrooms). All gypsum board joints shall be staggered each layer and each side. All gypsum board shall be fastened via the appropriate type and length of drywall screw. Hollow metal corner bead shall be used on all exposed vertical and horizontal edges. 7.1.1. Metal Studs @ Receptionist Wall: 20 gauge (min.). 7.1.2. Minimum Stud standard at all other full height walls: 3 5/8” metal studs @ 25 gauge. 7.1.3. Minimum Stud standard at Partial/Low height walls: 3 5/8” metal studs @ 16 gauge. 7.1.4. At all partitions, install gypsum board full height, embed joint tape in joint compound and apply first, fill (second), and finish (third) coats of joint compound over joints, angles, fastener heads, and accessories. Seal construction at perimeters, openings, and penetrations with a continuous bead of acoustical sealant including a bead at both faces of the partitions. 7.1.5. Frame door openings by attaching vertical studs at jambs with screws either directly to frames or to jamb anchor clips on door frames; install runner track section at head and secure to jamb studs. Install 2 studs at each jamb, extend double-jamb-studs continuous and attach to underside of floor or roof structure above.