PPSA 12.1 Terms used in clause 12 that are defined in the PPSA have the same meaning as in the PPSA. 12.2 Without limitation to other rights of the Company, from the time the Goods are in the possession of the Company or a Subcontractor, the Goods are subject to a continuing security interest in favour of the Company for the payment of all amounts due and owing by the Customer under the Agreement. 12.3 The Customer acknowledges and consents to the Company's registration and perfection of the Company's security interest under the Agreement for the purposes of the PPSA. 12.4 The Customer will not grant a security interest to another person, or allow any encumbrance to arise, in respect of the Goods. 12.5 To the extent permitted by law, the Customer irrevocably waives any right it may have to: (a) receive notices or statements under sections 95, 118, 121(4), 124(4), 125, 130, 132(3)(d) 132(4) and 135 of the PPSA; and (b) redeem the Goods under section 142 of the PPSA; (c) reinstate this Agreement under section 143 of the PPSA; and (d) receive a verification statement. 12.6 The Customer will do all things and execute all documents reasonably necessary to give effect to the security interest created under this Agreement or comply with any reasonable request by the Company in connection with the PPSA.
Manufacturing Standards All forest products except poles, produced and sold under this contract will be manufactured to maximize the amount of logs meeting preferred log lengths and to achieve the average log length listed. 97318 3 WS "WS" indicates that west side scaling rules apply. Minimum trim is 8 inches per scaling segment for west side scaling rules. "ES" indicates that east side scaling rules apply. Minimum trim is 4 inches per scaling segment for east side scaling rules. Poles produced under this contract will be manufactured to ANSI specifications (American National Standard Specifications and Dimensions for Wood Poles), in force at the time of signing this contract. a. Sweep will be limited to within the bole of the log as measured using a tape stretched between the centers of each end of the log. b. Logs approved by the state for peelers shall be chuckable with no more than a 2 inch diameter area of rot within a 5 inch diameter circle located at the center of either end of the log. c. Limbs and knots shall be cut flush, with no more than 15 percent of a log having limbs or knots over 2 inches in diameter extending more than 2 inches above the surface of the log.
Union Label All uniforms and clothing issued by the Employer shall bear a recognized Union label.
Licensing Standards The Contractor, its employees and subcontractors shall comply with all applicable licensing standards, certification standards, accrediting standards and any other laws, rules, or regulations governing services to be provided by the Contractor pursuant to this Contract. The State will not pay the Contractor for any services performed when the Contractor, its employees or subcontractors are not in compliance with such applicable standards, laws, rules, or regulations. If any license, certification or accreditation expires or is revoked, or any disciplinary action is taken against an applicable license, certification, or accreditation, the Contractor shall notify the State immediately and the State, at its option, may immediately terminate this Contract.
PRINCIPLES OF GOOD EMPLOYMENT PRACTICE The Supplier shall, and shall procure that each Sub-Contractor shall, comply with any requirement notified to it by the Customer relating to pensions in respect of any Transferring Former Supplier Employee as set down in: the Cabinet Office Statement of Practice on Staff Transfers in the Public Sector of January 2000, revised 2007; HM Treasury's guidance “Staff Transfers from Central Government: A Fair Deal for Staff Pensions of 1999; HM Treasury's guidance: “Fair deal for staff pensions: procurement of Bulk Transfer Agreements and Related Issues” of June 2004; and/or the New Fair Deal. Any changes embodied in any statement of practice, paper or other guidance that replaces any of the documentation referred to in Paragraph 5.1 shall be agreed in accordance with the Variation Procedure.