Common use of Setting conditions Clause in Contracts

Setting conditions. The setting conditions for the test to determine the net power are indicated in table 2. TABLE 2 - Setting conditions 1 Setting of carburettor(s) In accordance with the manufacturer's production specifications and used without further alteration for the particular application 2 Setting of injection pump delivery system 3 Ignition or injection timing (timing curve) 4 Governor setting 5 Anti-pollution devices */ Exhaust gas recirculation. UN ECE Regulation 24/03 52 5.3 Test conditions 5.3.1 The net power test shall consist of a run at full throttle for positive-ignition engines and at fixed full-load fuel injection pump setting for diesel engines, the engine being equipped as specified in table 1. 5.3.2 Performance data shall be obtained under stabilizing operating conditions with an adequate fresh air supply to the engine. The engines must have been run-in in accordance with the manufacturer's recommendations. Combustion ▇▇▇▇▇▇▇▇ may contain deposits, but in limited quantity. Test conditions, such as inlet air temperature, shall be selected as near to reference conditions (see 6.2) as possible in order to minimize the magnitude of the correction factor. 5.3.3 The temperature of the inlet air to the engine (ambient air) shall be measured within 0.15 m upstream of the point of entry to the air cleaner, or, if no air cleaner is used, within