QUANTITY CONTROL Clause Samples
QUANTITY CONTROL. The volumetric measurements presented by TERPEL will be accepted by THE AIRLINES as prove of delivered quantities. TERPEL undertakes to maintain its gages in perfect working condition, calibrating them with renowned laboratory calibration patterns considered valid by THE AIRLINES, who will be entitled to verify at any time the gage calibration performed by TERPEL. In the event of a claim by THE AIRLINES for shortages in a gage, TERPEL will carry out and perform the calibration in the presence of a representative from THE AIRLINES and if said decalibration is proved, TERPEL will recognize the shortage to THE AIRLINES, applying the volume that would have been supplied to THE AIRLINES by said gage, as of the date of the last calibration performed by TERPEL or its contractor to the gage in question until the date of recalibration in the presence of representatives from THE AIRLINES. Likewise, TERPEL shall assume any transportation and other expenses, if applicable, incurred by officers of THE AIRLINES who will travel to the supply locations to make sure the gages are properly calibrated, as long as there is a difference attributable to TERPEL.
QUANTITY CONTROL. If the weight of an individual piece prepared eatable is lesser or if lesser quantity of raw-material has been used than the reasonably prescribed limit by the Managing Committee/Bank, penalty will be imposed as per penalty clause mentioned in the agreement and suitable disciplinary action will be initiated against the defaulting canteen contractor/employees. Repeated penalties will result into the termination of the contract. ANNEXURE D DRAFT AGREEMENT This AGREEMENT is made at the day between Bank of Baroda a body corporate constituted under the Banking Companies (Acquisition & Transfer of Undertakings) Act 1970 having its Corporate Office at ………., , Bandra Kurla Complex, Bandra East Mumbai 400 051 (herein after referred to as the Bank which expression shall mean and include its successors and assigns) ON THE ONE PART AND with Shri resident of and Shri resident of as partners (hereinafter referred to as Contractor which expression shall mean and include the partners of the firm for the time being, their survivors or survivor, their respective legal heirs, executors and administrators) OF THE OTHER PART.
QUANTITY CONTROL. The volumetric measurements submitted by TERPEL will be accepted by the COMPANY as proof the quantities delivered. TERPEL undertakes to maintain the gauges in perfect operational conditions calibrating them every six (6) months (NTC 4643 SUPPLY), it being understood that the COMPANY may verify at any time the calibration of the gauges used by TERPEL. Should the COMPANY have any claim due to variations registered by a gauge, TERPEL will perform the calibration with the presence of a representative from the COMPANY and if any failure in the calibration is verified, TERPEL will recognize to the COMPANY the appropriate percentage, deducting applying it to the volume delivered to the COMPANY by such gauge, rom the date of the last calibration until the date when it is calibrated again in presence of the COMPANY’s representatives, to the complete satisfaction of the same. Likewise, TERPEL will bear any transportation and support expenses, if any, incurred by two officials of the COMPANY, who will travel to the places where the supply services is provided to verify the proper calibration of the gauges, provided there had been any difference attributable to TERPEL.