Push-On Joints Sample Clauses
Push-On Joints a. Where specified shall be the rubber ring compression, push-on type joint suitable for buried service.
b. Unless otherwise indicated, joints shall have an allowable deflection of up to 5 degrees at specified pressures.
c. Unless otherwise indicated, this joint is not permitted on fittings or specials.
d. Joint assembly and field cut joints shall be made in strict conformance with AWWA C600 and
e. Acceptable manufacturer:
1) American Cast Iron Pipe Company, Fastite Joint. 2) U.S. Pipe, Tyton Joint. 3)
Push-On Joints. Jointing shall be performed according to these specifications and the manufacturer's recommendations with special care used in cleaning gasket seat to prevent any dirt or sand from getting between the gasket and pipe. Lubricant to be used on the gasket shall be nontoxic and free from contamination. When a pipe length is cut, the outer edge of the cut shall be filed to a beveled edge to prevent injury to the gasket while joining.
Push-On Joints a. As specified in Section 15062, modified for restraint. b. Capable of being deflected after full assembly.