Know-How Necessary for the Business The Intellectual Property Rights are all those necessary for the operation of the Company’s businesses as it is currently conducted or as represented, in writing, to the Purchasers to be conducted. The Company is the owner of all right, title, and interest in and to each of the Intellectual Property Rights, free and clear of all liens, security interests, charges, encumbrances, equities, and other adverse claims, and has the right to use all of the Intellectual Property Rights. To the Company’s knowledge, no employee of the Company has entered into any contract that restricts or limits in any way the scope or type of work in which the employee may be engaged or requires the employee to transfer, assign, or disclose information concerning his work to anyone other than of the Company.
Unbundled Copper Loop – Designed (UCL-D) 2.4.2.1 The UCL-D will be provisioned as a dry copper twisted pair (2- or 4-wire) Loop that is unencumbered by any intervening equipment (e.g., filters, load coils, range extenders, digital loop carrier, or repeaters).
Trunk Group Connections and Ordering 5.2.1 For both One-Way and Two-Way Interconnection Trunks, if Onvoy wishes to use a technically feasible interface other than a DS1 or a DS3 facility at the POI, the Parties shall negotiate reasonable terms and conditions (including, without limitation, rates and implementation timeframes) for such arrangement; and, if the Parties cannot agree to such terms and conditions (including, without limitation, rates and implementation timeframes), either Party may utilize the Agreement’s dispute resolution procedures.
Requirements Pertaining Only to Federal Grants and Subrecipient Agreements If this Agreement is a grant that is funded in whole or in part by Federal funds:
Minority and Women’s Business Enterprises Compliance Award of this Contract was based, in part, on the Minority and/or Women’s Business Enterprise (“MBE” and/or “WBE”) participation plan as detailed in the Minority and Women’s Business Enterprises Subcontractor Commitment Form, commonly referred to as “Attachment A” in the procurement documentation and incorporated by reference herein. Therefore, any changes to this information during the Contract term must be approved by MWBE Compliance and may require an amendment. It is the State’s expectation that the Contractor will meet the subcontractor commitments during the Contract term. The following MBE/WBE Division (“Division”) certified MBE and/or WBE subcontractors will be participating in this Contract: [Add additional MBEs and WBEs using the same format.] MBE or WBE COMPANY NAME PHONE EMAIL OF CONTACT PERSON PERCENT Briefly describe the MBE and/or WBE service(s)/product(s) to be provided under this Contract and include the estimated date(s) for utilization during the Contract term: A copy of each subcontractor agreement must be submitted to the Division within thirty (30) days of the effective date of this Contract. The subcontractor agreements may be uploaded into Pay Audit (Indiana’s subcontractor payment auditing system), emailed to XXXXXxxxxxxxxx@xxxx.XX.xxx, or mailed to MWBE Compliance, 000 X. Xxxxxxxxxx Street, Indianapolis IN 46204. Failure to provide a copy of any subcontractor agreement may be deemed a violation of the rules governing MBE/WBE procurement and may result in sanctions allowable under 25 IAC 5-7-8. Requests for changes must be submitted to XXXXXxxxxxxxxx@xxxx.XX.xxx for review and approval before changing the participation plan submitted in connection with this Contract. The Contractor shall report payments made to Division certified subcontractors under this Contract on a monthly basis using Pay Audit. The Contractor shall notify subcontractors that they must confirm payments received from the Contractor in Pay Audit. The Pay Audit system can be accessed on the IDOA webpage at: xxx.xx.xxx/xxxx/xxxx/xxxxxxxx.xxx. The Contractor may also be required to report Division certified subcontractor payments directly to the Division, as reasonably requested and in the format required by the Division. The Contractor’s failure to comply with the provisions in this clause may be considered a material breach of the Contract.
Unbundled Copper Loop – Non-Designed (UCL-ND 2.4.3.1 The UCL–ND is provisioned as a dedicated 2-wire metallic transmission facility from BellSouth’s Main Distribution Frame (MDF) to a customer’s premises (including the NID). The UCL-ND will be a “dry copper” facility in that it will not have any intervening equipment such as load coils, repeaters, or digital access main lines (DAMLs), and may have up to 6,000 feet of bridged tap between the End User’s premises and the serving wire center. The UCL-ND typically will be 1300 Ohms resistance and in most cases will not exceed 18,000 feet in length, although the UCL-ND will not have a specific length limitation. For Loops less than 18,000 feet and with less than 1300 Ohms resistance, the Loop will provide a voice grade transmission channel suitable for Loop start signaling and the transport of analog voice grade signals. The UCL-ND will not be designed and will not be provisioned with either a DLR or a test point.
Information Technology Enterprise Architecture Requirements If this Contract involves information technology-related products or services, the Contractor agrees that all such products or services are compatible with any of the technology standards found at xxxxx://xxx.xx.xxx/iot/2394.htm that are applicable, including the assistive technology standard. The State may terminate this Contract for default if the terms of this paragraph are breached.
Contractor Licensing, etc. Notwithstanding Section 14.c, District may terminate this Contract immediately by written notice to Contractor upon denial, suspension, revocation, or non-renewal of any license, permit, or certificate that Contractor must hold to provide services under this Contract.
Documents & Data; Licensing of Intellectual Property This Agreement creates a non-exclusive and perpetual license for City to copy, use, modify, reuse, or sublicense any and all copyrights, designs, and other intellectual property embodied in plans, specifications, studies, drawings, estimates, and other documents or works of authorship fixed in any tangible medium of expression, including but not limited to, physical drawings or data magnetically, electronically or otherwise recorded or stored, which are prepared or caused to be prepared by Consultant under this Agreement (“Documents & Data”). All Documents & Data shall be and remain the property of City, and shall not be used in whole or in substantial part by Consultant on other projects without the City's express written permission. Within thirty (30) days following the completion, suspension, abandonment or termination of this Agreement, Consultant shall provide to City reproducible copies of all Documents & Data, in a form and amount required by City. City reserves the right to select the method of document reproduction and to establish where the reproduction will be accomplished. The reproduction expense shall be borne by City at the actual cost of duplication. In the event of a dispute regarding the amount of compensation to which the Consultant is entitled under the termination provisions of this Agreement, Consultant shall provide all Documents & Data to City upon payment of the undisputed amount. Consultant shall have no right to retain or fail to provide to City any such documents pending resolution of the dispute. In addition, Consultant shall retain copies of all Documents & Data on file for a minimum of five (5) years following completion of the Project, and shall make copies available to City upon the payment of actual reasonable duplication costs. In addition, before destroying the Documents & Data following this retention period, Consultant shall make a reasonable effort to notify City and provide City with the opportunity to obtain the documents.
Certified and Minority Business Enterprises Reports Upon Customer request, the Contractor shall report to the requesting Customer the Contractor’s spend with certified and other minority business enterprises in the provision of commodities or services related to the Customer’s orders. These reports shall include the period covered, the name, minority code, and Federal Employer Identification Number of each minority business utilized during the period; commodities and services provided by the minority business enterprise, and the amount paid to each minority business enterprise on behalf of the Customer.
