Metering Location Clause Samples
Metering Location. Metering of capacity and energy purchased from the QF will normally be accomplished at the point of delivery. If point-of-delivery metering is not practical, metering may be established at other locations. Exact location will be determined on a site-specific basis. All metering will be compensated to the point of delivery.
Metering Location. The locations of the Metering Installations are defined in item [7] (“Transmission Network Connection”) of Schedule 1 of the Works Coordination Agreement.
Metering Location. (Check one) Seller elects metering location pursuant to Section 8 as follows: ___Edison's side of the Interconnection Facilities X Seller's side, of the Interconnection Facilities. Loss compensation factor --- is equal to (to be determined), pursuant to Section 8.3. General Terms & Conditions
Metering Location. Seller elects metering location pursuant to Section 8 as follows: Seller's side of the Interconnection Facilities. Loss compensation factor is equal to .5%, pursuant to Section 8.3.
Metering Location. The measurement point for all Performance Tests, unless stated otherwise below, shall be the Facility meter located on the 34.5kV bus in the project substation (the “Facility Meter”), adjusted to account for losses between this meter and the POI, as described in Exhibit B-1.
Metering Location. (Check one) Seller elects metering location pursuant to Section 8 as follows: _____ Edison's side of the Interconnection Facilities X Seller's side, of the Interconnection Facilities. Loss compensation ------ factor is equal to (to be determined), pursuant to Section 8.3. July 8, 1987 ▇▇▇▇▇ ▇▇▇▇▇▇ indicated no transformer to be used, project to be directly connected to 115 kV system, therefore no transformer losses associated with this project. --▇▇▇▇ ▇▇▇▇▇▇▇▇▇▇ General Terms & Conditions
Metering Location. The locations of the Metering Installations are defined in Diagram 1 (“Transmission Network Connection”) of Schedule 1 (“Powerlink Assets”).
Metering Location. The two parties agree with each other on the metering locations of metering systems as follows: - Main metering location: …. - Backup metering location 1: …. - Backup metering location 2: …. - Output separation and metering location (if any): …