Meter replacement Clause Samples
The Meter Replacement clause outlines the procedures and responsibilities related to replacing utility meters, such as those measuring electricity, water, or gas usage. Typically, this clause specifies when a meter may be replaced, who is authorized to perform the replacement, and how notification and access are managed. For example, it may require the utility provider to notify the property owner in advance or to ensure that the new meter is properly calibrated. The core function of this clause is to ensure accurate measurement of utility consumption and to clarify the process for updating or maintaining essential metering equipment, thereby preventing disputes over usage and billing.
Meter replacement. We will replace the meter and/or any pipe-work and fittings up to the meter if required at no cost to you if the meter: • is found to be defective; • can no longer be reasonably maintained; or • is replaced as part of a meter replacement program.
Meter replacement. Organising and managing meter replacements to ensure installation compliancy for Consumers. This includes several Consumers that have a direct metering contract with Stream.
Meter replacement. 9.1. The MAP shall repair or replace faulty meters within two (2) working days of being notified of such faults. Where a MAP fails to repair or replace a meter within two (2) working days of a report by the customer or Distribution Company, the customer shall not be liable for the payment of Metering Service Charge for the billing period unless such delays were as a result of inaccessibility to the customer's premises
9.2. Any meters to be replaced in accordance with the above criteria that are installed inside premises where customers permission needs to be sought before meter auditors can have access should be re-installed such that meter auditors do have access at all times
9.3. Prior to the replacement of any meter the MAP shall observe the provisions of Clause 13 of this Schedule.
9.4. The sequencing of customers for meter check will be in accordance with the Project Management provisions at clause 16.
9.5. MAP will provide to EKEDP on a daily basis for each day when meters have been replaced as a part of the Daily Meter Installation Report, providing information on:
a) each meter installed including customer number, address and/ or GPS coordinates, meter number, type, meter location, units pre-loaded (for pre-payment meters).
b) readings from the meter that has been replaced in accordance with clause 13 of this Schedule.
Meter replacement. We will replace the m eter at no cost to you if the meter: • is found to be defective; • if it can no longer be reasonably maintained; or • is replaced as part of a meter replacement program. We will attempt to notify you at the time of replacement and advise you that a new meter ha s been installed. A mutually acceptable time will be negotiated with commercial customers for the replacement of meters.
Meter replacement. We will replace the Meter at no cost to you if the Meter: • is found to be defective • can no longer be reasonably maintained; or • is replaced as part of a Meter replacement program. If we incur additional costs to replace the Meter because of actions by you (eg restricted access to the Meter, structural work at or near the Meter), you have to pay us those additional costs. We will attempt to notify you at the time of replacement and advise you that a new Meter has been installed.
Meter replacement. Within about a week, your utility company will change your meter if needed. The utility company will then give an interconnection approval for your solar system.