Measurement Method E Clause Samples

Measurement Method E. Read-Only Multi (R) From Bus Line (1) Particle counter connection F4 (2) Measurement parameter setting [Measure] → [Setup] or Refer to section 7 "Measurement Steps for Each Measurement Method" and set the pa- rameters for measurement method E. Toolbar (3) Measurement start [Measure] → [Start] or Starts the process for receiving measurement data from the particle counters. - In this mode, measurement data can only be received if the master RP Monitor is currently carrying out measurement. Control of particle counters by RP Monitor and control of master RP Monitor is not possible. - The measurement count may be different from the master RP Monitor. This is due to different handling of communication errors. (When a D=2 error or similar has occurred at the master, the slave discards these data as invalid.) - The Command column of the real-time display shows only "Count n". Other com- mands such as "LDON" or "Stop" cannot be shown. - When "Dispens Times", "Ave Times", "MEAS Times" etc. have been set, measure- ment must be started simultaneously with the master RP Monitor, otherwise results will be different. - If an unrecoverable error (disk full error, etc.) occurs during measurement, mea- surement data receive is stopped. - Measurement time information is sent at regular intervals from the master RP monitor for time matching at the slave computer, so that there will be no shift in measurement time. Toolbar