Common use of Initial Interconnection Clause in Contracts

Initial Interconnection. a) Upon satisfactory completion of the review process and execution of this Agreement, the Cooperative will begin installation of the interconnection of DG facilities. The interconnection will be completed as soon as practical after completion of the review process and execution of the necessary agreements and contracts. After completion of interconnection requirements and prior to initiation of service, the Cooperative will conduct a final inspection of the facilities and interconnection to the Cooperative’s system. Upon satisfactory final inspection, the Cooperative will initiate service to the Member. b) The Cooperative’s review process and final inspection is a means to safeguard the Cooperative’s facilities and personnel. The Member acknowledges and agrees that any review or acceptance of such plans, specifications, and other information by the Cooperative or its Power Supplier shall not impose any liability on the Cooperative or its Power Supplier and does not guarantee the adequacy of the Member’s equipment or DG facility to perform its intended function. The Cooperative and its Power Supplier disclaim any expertise or special knowledge relating to the design or performance of Member’s specific generating installation and do not warrant the efficiency, cost-effectiveness, safety, durability, or reliability of such DG installation. c) The initial inspection is conducted at no charge to the Member party. If the initial inspection results in failure due to the installation not meeting the installation requirements, in the sole discretion of the Cooperative, then all subsequent inspections will incur a $250 inspection charge. Refer to Exhibit A for instructions for all system installation requirements.