Harmonic Control Clause Samples

Harmonic Control. Each Party shall design, construct, operate, maintain and use its electric facilities in accordance with the IEEE 519 standard and Good Utility Practice to reduce to acceptable levels the harmonic currents and voltages which pass into the other Party's facilities. Harmonic reductions shall be accomplished with equipment that is specifically designed and permanently operated and maintained as an integral part of the facilities of the Party that owns the system on which harmonics are generated.

Harmonic Control. The Seller shall perform harmonic testing to confirm compliance of the requirements and recommendations contained in [IEEE Standard 519-1991].

Harmonic Control. 15 APPLICABLE ONLY IF TRANSFEREE IS NOT A PARTY TO THIS CONTRACT 36. Protection of the Transferor...................................... 15 RELATING ONLY TO RURAL ELECTRIFICATION BORROWERS 37. Approval of Contract.............................................. 15 APPLICABLE ONLY IF BONNEVILLE IS THE TRANSFEROR 38. Equitable Adjustment of Rates..................................... 15 -------------------------------------------------------------------------------- GENERAL APPLICATION -------------------

Harmonic Control. Each Party shall design, construct, operate, maintain, and use its electric facilities in accordance with Prudent Utility Practice to reduce, to acceptable levels, the harmonic currents and voltages which pass into the other Party's facilities. To that end, the Parties shall be guided by the recommended practices and requirements for harmonic control specified in The Institute of Electrical and Electronics Engineers, Inc. (IEEE) Electrical Power System Standard 519-1992, or its successor. The Parties shall accomplish harmonic reductions using equipment which is specifically designed, and permanently operated and maintained, as an integral part of the facilities of the Party which owns the system on which the harmonics are generated. Contract No. 95MS-94854 Exhibit A, Page 8 of 8 Contract N▇. ▇▇▇▇-▇▇▇▇▇ ▇▇▇▇▇▇▇▇ ▇▇▇▇▇▇▇▇ ▇▇▇▇. Effective on the Commencement Date (e) Voltage Flicker Voltage flicker is normally detectable through visible variations in light intensity. However, flicker may be present even when no light variations are detectable. Since flicker is disruptive to lighting and can damage computer equipment, it must be controlled. IEEE Recommended Practices and Requirements for Harmonic Control in Electric Power Systems, (IEEE Standard 519) provides definitions and limits on acceptable levels of voltage flicker, as set by IEEE Standard 519. Both Parties shall control voltage flicker on their respective systems as required by IEEE Standard 519.