General ▇▇▇▇▇▇▇▇ and Correction of Work Clause Samples

General ▇▇▇▇▇▇▇▇ and Correction of Work. (a) In addition to any special guarantees or warranties contained in the Contract Documents, the Contractor warrants to the Owner that all materials and equipment furnished in performance of the Work will be new unless otherwise specified, and that all Work will be of good quality, free from faults and defects and in conformance with the Contract Documents. All work not so conforming to these standards shall be considered defective. (b) The Contractor shall promptly correct all defective Work to comply with the Contract Documents whether observed before or after the substantial completion date and whether or not fabricated, installed or completed. The Contractor shall bear all costs of correcting defective Work. (c) If, within one (1) year after the substantial completion date, or within such longer period of time as may be prescribed by law or by the terms of any applicable special guarantee or warranty required by the Contract Documents, any of the Work is found to be defective and not in accordance with the Contract Documents, the Contractor shall correct it promptly after receipt of a written notice from the Owner, or the Engineer, to do so. (d) All defective or non-conforming Work shall be removed from the site of the Work if necessary, and the Work shall be corrected to comply with the Contract Documents without cost to the Owner. The Contractor also shall bear the cost of making good all work of other contractors destroyed or damaged by removal or correction of the defective Work of Contractor.
General ▇▇▇▇▇▇▇▇ and Correction of Work. (a) In addition to any special guarantees or warranties contained in the Contract Documents, the ▇▇▇▇ warrants to the Owner that all materials and equipment furnished in performance of the Work will be new unless otherwise specified, and that all Work will be of good quality, free from faults and defects in workmanship and materials and in conformance with the Contract Documents. All work not so conforming to these standards shall be considered defective. For any delegated design or other design services required by ▇▇▇▇ pursuant to the Contract Documents, shall be performed in conformity with the ordinary standard of care that a reasonable designer would exercise on the same type of project, at the same time and in the same place, and under the same or similar circumstances and conditions. All construction Work resulting from any delegated design services shall be subject to the warranties provided herein. (b) The ▇▇▇▇ shall promptly correct all defective Work to comply with the Contract Documents whether observed before or after the substantial completion date and whether or not fabricated, installed or completed The ▇▇▇▇ shall bear all costs of correcting defective Work. (c) If, within one (1) year after the Substantial Completion Date, or within such longer period of time as may be prescribed by law or by the terms of any applicable special guarantee or warranty required by the Contract Documents, any of the Work is found to be defective and not in accordance with the Contract Documents, the ▇▇▇▇ shall correct it promptly after receipt of a written notice from the Owner, or the Engineer, to do so. (d) All defective or non-conforming Work shall be removed from the site of the Work if necessary, and the Work shall be corrected to comply with the Contract Documents without cost to the Owner. The ▇▇▇▇ also shall bear the cost of making good all work of other contractors destroyed or damaged by removal or correction of the defective Work of ▇▇▇▇. (e) If the ▇▇▇▇ fails to timely and properly correct defective Work, the Owner may correct it and hold the ▇▇▇▇ liable for all costs, expenses and damages, including attorney’s fees and litigation costs incurred by Owner in correcting it. (f) In addition to the foregoing warranty, a warranty period of one (1) year shall apply under the same terms and conditions as the original warranty, to any work, supplied in correction ofof defective work under warranty pursuant to the provisions of this Section 15.4 and the ▇▇▇...

Related to General ▇▇▇▇▇▇▇▇ and Correction of Work

  • Uncovering and Correction of Work 12.1 The Contractor shall promptly correct Work rejected by the Owner or failing to conform to the requirements of the Contract Documents, whether observed before or after Substantial Completion and whether or not fabricated, installed or completed, and shall correct any Work found to be not in accordance with the requirements of the Contract Documents within a period of two years from the date of Substantial Completion, or by terms of an applicable special warranty required by the Contract Documents. The provisions of this Article apply to work done by Subcontractors as well as to Work done by direct employees of the Contractor. 12.2 At any time during the progress of the work, or in any case where the nature of the defects shall be such that it is not expedient to have them corrected, the Owner, at their option, shall have the right to deduct such sum, or sums, of money from the amount of the contract as they consider justified to adjust the difference in value between the defective work and that required under contract including any damage to the structure.

  • CORRECTION OF WORK 13.2.1 The Contractor shall be responsible for correcting all Work which the Architect has found to be defective or which fails to conform to the Contract Documents whether observed be- fore or after Substantial Completion and whether or not fabricated, installed or completed. The Contractor shall bear all costs of correcting such rejected Work, including compensation for the Architect's and the State’s additional services made necessary thereby. 13.2.2 If, within one year after the Date of Substantial Completion of the Work or designated portion thereof or within one year after acceptance by the State of designated equipment or within such longer period of time as may be prescribed by law or by the terms of any applicable special warranty required by the Contract Documents, any of the Work is found to be defective or not in accordance with the Contract Documents, the Contractor shall correct it promptly after receipt of a written notice from the State to do so unless the State has previously given the Contractor a written acceptance of such condition. This obligation shall survive termination of the Contract. The State shall give such notice promptly after discovery of the condition. 13.2.3 The Contractor shall remove from the site all portions of the Work which are defective or non-conforming and which have not been corrected under Subparagraphs 4.5.1, 13.2.1 and 13.2.4 If the Contractor fails to correct defective or nonconforming Work as provided in Subparagraphs 4.5.1, 13.2.1 and 13.2.2, the State may correct it in accordance with Paragraph 13.2.5 If the Contractor does not proceed with the correction of such defective or non- conforming Work within a reasonable time fixed by written notice from the Architect, the State may remove it and may store the materials or equipment at the expense of the Contractor. If the Contractor does not pay the cost of such removal and storage within ten days thereafter, the State may upon ten additional days written notice sell such Work at auction or at private sale and shall account for the net proceeds thereof, after deducting all the costs that should have been borne by the Contractor, including compensation for the Architect's and the State’s additional services and expenses made necessary thereby. If such proceeds of sale do not cover all costs which the Contractor should have borne, the difference shall be charged to the Contractor and an appropriate Change Order shall be issued. If the payments then or thereafter due the Contractor are not sufficient to cover such amount, the Contractor shall pay the difference to the State. 13.2.6 The Contractor shall bear the cost of making good all work of the State or separate contractors destroyed or damaged by such correction or removal. 13.2.7 Nothing contained in this Paragraph 13.2 shall be construed to establish a period of limitation with respect to any other obligation which the Contractor might have under the

  • Inspection of Work It is FIRST PARTY's obligation to make the work product available for CITY's inspections and periodic reviews upon request by CITY.

  • Statement of Work The Statement of Work to which Grantee is bound is incorporated into and made a part of this Grant Agreement for all purposes and included as Attachment A.

  • Location of Work The Executive shall be based in the United States in West Orange, New Jersey. However, the Executive agrees to undertake whatever domestic and worldwide travel is required by the Company. The Executive shall not be required or permitted to relocate without the mutual, written consent of the Executive and the Company.