FOREARM POCKETS Clause Samples

FOREARM POCKETS. The garment shall also have two forearm pockets located 2” up from the cuff edge on each sleeve. These forearm pockets shall measure 5” wide by 7” tall and shall be secured using a 6” YKK nylon coil zipper with a welt closure construction. The pocket shall be made using the same outer facing material as the jacket to ensure consistency and shall be back with the same waterproof/breathable hydrophilic polyurethane membrane to ensure performance. Two large inside pockets are to be in the garment constructed of two layers of tricot with a bound opening at the top. The inside pockets shall extend from the center front to the front seam of the side panels. There shall be a tunneled draw cord at the bottom sweep on the front of the jacket. The tunnel shall be created by folding under the shell fabric at base of garment. The draw cord shall be elasticized and the ends sewn down inside the tunnel at the front ends and shall exit the tunnel at either side of the garment using two finished button holes. At the exits the draw cord shall have a bead and barrel lock to allow the cord to be tightened. There shall be a snap tab on each front seam of the side panel on the inside of the garment up from the bottom to secure the elasticized shock cord when tightened. The snaps on the tabs shall be compression nipple snaps. The back bottom inside band of the garment shall have an elasticized gripper. Colors Black (003); Dark Navy (011) Sizes Regular: S – 5XL Long: M – 5XL The Manufacturer must meet the minimum requirements listed below. Failure to meet any requirement will result in immediate disqualification of bid.