Entering Attributes Sample Clauses

Entering Attributes. For points, MobileMapper Field will prompt you to enter the attribute values before you log the point (case of instantaneous measurement). If an average time greater than 0 is used, attribute values may be entered before starting the averaging process, during the averaging process, and after the averaging time has elapsed (i.e. as long as you have not logged the point). For lines and polygons, attribute values may be entered at any time after touching . MobileMapper Field will always prompt you to enter these values both at the beginning (before touching ) and at the end (before touching ) of the data collection. Note that the values of Averaging time, Antenna Height, Position Filter, Log by and Logging interval you choose will be kept unchanged until you decide to use another value for each of these parameters. Setting the Antenna Height‌ Accessing the antenna height setting is possible in the following context: • Open a job. • Touch and choose any of the available layers. • Touch and select Antenna height. • Enter the value of antenna height, expressed in the chosen unit, and then touch OK. Setting the Averaging Time for Point Features Accessing the averaging time setting is possible in the following context:‌‌ • Open a job. • Touch and choose any of the available point-type layers. • Touch and select Averaging time. • Scroll the field up or down until you get the desired value (in seconds) between the two horizontal blue lines and then touch OK. Setting the Position Filter‌‌ Accessing the position filter setting is possible in the following context: • Open a job. • Touch and choose any of the available layers. • Touch and select Position filter. • Enter the desired value of position filter, expressed in the chosen unit, and then touch OK. Setting the Logging Mode for Lines & Polygons‌ • Open a job. • Touch . • Select a layer, of the line or polygon type. • Touch and select Logging mode. • Select the desired mode (Automatic or Manual) and touch