Common use of Design data Clause in Contracts

Design data. The Contractor shall provide the Instrument design, test, and verification data outlined in the following paragraphs. 5.3.1 Requirements Verification Plan (CDIL D-4) The Contractor shall develop and maintain an Instrument Requirements Verification Plan. The plan will address the verification approach for each system level requirement in the Instrument Specification to include verification method (e.g. test, analysis, etc.), verification level (e.g. component, subsystem, system), and documentation approach. DigitalGlobe approval is required for the verification plan. The Contractor will provide the initial plan at CDR. 5.3.2 Instrument Level Requirements Verification / Compliance Matrix (CDIL D-5) The Contractor shall develop and maintain a Requirements Verification/Compliance Matrix (RVCM) including the following information for the Instrument Specification: a. Specification paragraph b. Paragraph title c. Summary description of requirement d. Column indicating status of compliance e. Summary description of budgeted and measured performance, including margin f. Verification Level [**Redacted**] g. Verification Point [**Redacted**] h. Verification Method [**Redacted**] i. Verification Source Document indicating applicable paragraph, test sheet, etc. j. Comments, if required. k. Other information at the Contractor’s option The Contractor shall update the RVCM at CDR, and monthly beginning at the first component Acceptance Test Procedure through Instrument Final Acceptance. DigitalGlobe Proprietary and Confidential Use or disclosure of data is subject to the restriction on the title page of this document.