LOST, STOLEN OR DAMAGED CARDS If the Cardmember loses the Card or if the Card is damaged or stolen or if the PIN became available to any other persons, the Cardmember must immediately inform AEME by telephone. In addition, the Cardmember shall provide AEME with a written notification within 3 days from the date of the occurrence of any of the above listed events, as per applicable laws. All notices pursuant to this article must be sent to the following address: AMEX (Middle East) B.S.C. (c), P.O. Box 5990, Manama, Kingdom of Bahrain. Or facsimile number: (+000) 00 000000. To inform AEME by phone, call the number indicated in the Cardmember Additional Information Leaflet. If AEME is duly informed in the manner described above the Cardmember shall not be liable for any Charges made on his or her Card by any third parties after the Card has been reported lost or stolen. Failure to comply with the provisions of this article will render the Cardmember liable for all Transactions made on his or her lost or stolen Card until the time the Card is reported as lost or stolen to AEME. However, the Cardmember shall at all times be fully liable for all Charges including Cash Withdrawals even if these Charges were made by third parties if these third parties gained possession of the Card or any Supplementary Card or the PIN with the knowledge, permission, approval or other acts of the Cardmember or any Supplementary Cardmember or because of their negligence. If the Card is found after it was reported lost or stolen, the Cardmember may not use or attempt to use the Card at issue and shall immediately inform AEME which will take the appropriate action.
REPAIRED OR REPLACED PARTS / COMPONENTS Where the Contractor is required to repair, replace or substitute Product or parts or components of the Product under the Contract, the repaired, replaced or substituted Products shall be subject to all terms and conditions for new parts and components set forth in the Contract including Warranties, as set forth in the Additional Warranties Clause herein. Replaced or repaired Product or parts and components of such Product shall be new and shall, if available, be replaced by the original manufacturer’s component or part. Remanufactured parts or components meeting new Product standards may be permitted by the Commissioner or Authorized User. Before installation, all proposed substitutes for the original manufacturer’s installed parts or components must be approved by the Authorized User. The part or component shall be equal to or of better quality than the original part or component being replaced.
Returns, Damaged or Defective Goods Our policy in relation to Returns, Damaged or Defective Goods shall be as specified in Our standard Terms and Conditions for the supply of Goods and Services. We shall not accept returns for change of mind or if You make a wrong decision unless due to our negligence or incorrect information supplied by Ourselves. Copyright and Trademarks The contents of this Website are at all times the copyright or trademark property of either Ourselves, Our suppliers or linked third parties and You may not distribute, reproduce, display, publish any trademark or other content of this Website for any purpose whatsoever without the prior written approval of Us, Our suppliers or linked third parties (each as applicable). Furthermore You agree to indemnify Us against any claims, costs, damages or losses incurred by Us should You fail to comply with this clause. Advertisers and Linked Sites The display on Our Website of any advertiser or the provision of a link to third party Websites does not constitute Our endorsement of either the advertiser or third party provider or any of their Website content or business practices. As We do not have any control of the content of any third party Websites, access to such Websites is at Your sole risk and We recommend that You thoroughly review the terms and conditions of use and the Privacy policies of any third party Website immediately once You access such a Website. We shall accept no liability in regards to any dealings, promotions or activities between Yourself and advertisers or third party providers. Specifications and Information Specifications and information provided on this Website are given in good faith based on Our knowledge, experience, or information provided to Us by manufacturers and/or suppliers, or derived from sources believed to be accurate at the time the information is received by Us, therefore it is recommended if You have any concerns as to the suitability of Goods or Services provided through this Website in respect of the use of the Goods or Services or their suitability for a particular use that You contact Us or seek external professional opinion. You acknowledge and accept that colours of items displayed on the Website may not reflect the true and actual colour of such items as this may be affected by external influences such as the quality of images supplied to Us for use, or the quality, age or settings on Your monitor. If colour is a major factor in Your decision making We recommend You contact Us before purchase. On-Line Ordering Display on this Website does not guarantee the availability of any particular Good(s) therefore all orders placed through this Website shall be subject to confirmation of acceptance by Us. Orders for Services shall be subject to confirmation of suitable timeframes between You and Ourselves for provision of the Services. Continuous Service Due to the inherent nature of Websites We cannot guarantee uninterrupted or continuous availability of this Website and You accept that the Website may also be unavailable from time to time for maintenance or scheduled upgrades. Where able We shall give You advanced warning of the same. We shall accept no liability in relation to Website downtime whether scheduled or otherwise.
Purchased Equipment Any equipment purchased under this contract remains the property of the Contractor for the period this contract and future continuing contracts for the provision of the same services. Contractor must submit vendor invoice with reimbursement request. For the purpose of this contract, equipment is defined as any tangible, durable property having a useful life of at least (1) year and acquisition cost of $1000.00 or more. The contractor has the responsibility to submit to the Contract Monitor an inventory list of LDH equipment items when acquired under the contract and any additions to the listing as they occur. Contractor will submit an updated, complete inventory list on a quarterly basis to the Contract Monitor. Contractor agrees that upon termination of contracted services, the equipment purchased under this contract reverts to the Department. Contractor agrees to deliver any such equipment to the Department within 30 days of termination of services.
Loop Provisioning Involving Integrated Digital Loop Carriers 2.6.1 Where InterGlobe has requested an Unbundled Loop and BellSouth uses IDLC systems to provide the local service to the End User and BellSouth has a suitable alternate facility available, BellSouth will make such alternative facilities available to InterGlobe. If a suitable alternative facility is not available, then to the extent it is technically feasible, BellSouth will implement one of the following alternative arrangements for InterGlobe (e.g. hairpinning):
REPAIRED OR REPLACED PRODUCTS, PARTS, OR COMPONENTS Where the Contractor is required to repair, replace or substitute Product or parts or components of the Product under the Contract, the repaired, replaced or substituted Products shall be subject to all terms and conditions for new parts and components set forth in the Contract including warranties, as set forth in the Warranties clause herein. Replaced or repaired Product or parts and components of such Product shall be new and shall, if available, be replaced by the original manufacturer’s component or part. Remanufactured parts or components meeting new Product standards may be permitted by the Commissioner or Authorized User. Before installation, all proposed substitutes for the original manufacturers’ installed parts or components must be approved by the Authorized User. The part or component shall be equal to or of better quality than the original part or component being replaced.
Integrated Digital Loop Carriers The feeder portion of some loops may be provide by means of Integrated Digital Loop Carrier (IDLC). IDLC provides a fiber optic cable transmission path that travels directly into BellSouth’s central office local switch. Where BellSouth uses IDLC ,if technically feasible and capacity does exist, BST will provide Al-Call with a Designed DS0 UVL by using alternative provisioning techniques including but not limited to such as “hairpinning” and DAC grooming. Alternative provisioning techniques will be provided at no additional cost to Al-Call . Hairpinning involves providing a DS0 signal from an IDLC-served loop to Al-Call ’s collocation equipment by using a dedicated pathway that traverses BellSouth’s central office switch. BellSouth will provide such DS0 signal to Al-Call by establishing a copper cross connect between the BellSouth switch and Al-Call ’s collocation equipment.
Equipment Use Lessee agrees that the Equipment will be operated by competent, qualified personnel in connection with Lessee's business for the purpose for which the Equipment was designed and in accordance with applicable operating instructions, laws, and government regulations, and that Lessee shall use all reasonable precautions to prevent loss or damage to the Equipment from fire and other hazards. Lessee shall procure and maintain in effect all orders, licenses, certificates, permits, approvals, and consents required by federal, state, or local laws or by any governmental body, agency, or authority in connection with the delivery, installation, use, and operation of the Equipment.
Life support equipment (a) If a person living at your premises requires life support equipment, you must register the premises with your retailer or with us. To register, you will need to give written confirmation from a registered medical practitioner of the requirement for life support equipment at the premises.
Tandem Transit Traffic 12.1 As used in this Section, Tandem Transit Traffic is Telephone Exchange Service traffic that originates on CBB's network, and is transported through Verizon’s Tandem to the subtending End Office or its equivalent of another carrier (CLEC, ILEC other than Verizon, Commercial Mobile Radio Service (CMRS) carrier, or other LEC (“Other Carrier”). Neither the originating nor terminating customer is a Customer of Verizon. Subtending End Offices shall be determined in accordance with and as identified in the Local Exchange Routing Guide (LERG). Switched Exchange Access Service traffic is not Tandem Transit Traffic.
