Conditioning. The pre-loading device may be separated from the safety-belt to be tested and kept for 24 hours at a temperature of 60 ± 5 °C. The temperature shall then be raised to 100 ± 5 °C for two hours. Subsequently it shall be kept for 24 hours at a temperature of -30 ± 5 °C. After being removed from conditioning, the device shall warm up to ambient temperature. If it has been separated it shall be fitted again to the safety-belt.
Conditioning. CLEC may order conditioning of shared lines, which may involve: (a) the removal of bridge taps, filter, extenders and load coils; (b) a line and station transfer; and/or (c) Digital Added Main Line (DAML) (consistent with the provisions of section 2.13 of this Agreement). VERIZON will perform loop conditioning if the loop loss for voice services is less than –8.0dB. Conditioning will not be provided in circumstances where such conditioning significantly degrades other advanced services or traditional voice band services as provided and described in FCC Rules 51.230, 51.233 and paragraphs 85, 86 and 201-205 of the Line Sharing Order.
Conditioning. At Gulf Coast’s request, and for the charge(s) described on Appendix A, GTE will condition those lines that are unbundled pursuant to this Attachment to remove load coils, bridge taps, low pass filters, range extenders and other devices to allow such lines to be provisioned in a manner that will allow for the transmission of digital signals required for ISDN and ADSL services, or, in the case of analog lines, to meet specific transmission parameters (e.g., Type C, Type DA, Improved C). dedicated transport may be conditioned for DS-1 clear channel capability.
Conditioning. 1.2.1 Upon completion of the Local Service Request (LSR) for the LS One service, Carrier may submit, via trouble ticket, a request for AT&T-13STATE to condition the CO-HFS provisioned to Carrier under this Agreement. Carrier shall specify on its conditioning-related trouble ticket the specific conditioning work it is requesting that AT&T-13STATE perform on its behalf. For newly installed CO-HFS’, Carrier will not be billed any additional charge for any conditioning work required for AT&T-13STATE to perform for the CO-HFS to meet appropriate ANSI Standards (i.e., for the removal of repeaters, excessive bridged taps and/or load coils).