Chain Mesh Clause Samples

Chain Mesh. Chain mesh shall be Heavy Galvanized (HG) wire (Class W10) 3.15mm “Heavy Duty” 3.6 metre high, Standard diamond size 45mm pitch suitable for coastal environments with a 10 year warranty. The wire end finish is Knuckle - Knuckle at both ends. The chain-wire mesh wire shall be: • installed on the outside of all posts (as per manufactures requirements) • securely laced to corner posts • fully laced through each diamond with 2mm wire to end posts, internal corner posts, gate posts and pipe rails with a minimum of two full twists • tied to intermediate posts using a single loop of wire that is securely tightened at intervals of not less than 480mm (each sixth diamond) with a minimum of two full twists • tied to cable wires using a single loop of wire that is securely tightened at intervals of not less than 480mm (each sixth diamond) with a minimum of two full twists or, optionally, secured with 2.24mm wire netting clips at 320mm spacings When correctly installed, the mesh should be taut and there should be no separation greater than 5.0mm between each loop of any knuckle, when the diamonds are squeezed using hand pressure.