Cabinet. The cabinet shall be equipped with a nozzle(s) which provides a solid cone water spray of sufficient angle to completely cover the sample device. The centreline of the nozzle(s) shall be directed downward at an angle of 45°± 5° to the vertical axis of a rotating test platform.
Cabinet. HARDWARE .1 Door Hinges: .1 135° degrees, fully adjustable, concealed, 110° degrees, fully adjustable, concealed where requested, .2 Acceptable materials: Blum, Hettich, Salice, .3 Soft Closing doors and drawers may be required; .2 Door “D” Pull and Drawer Pulls: .1 128 mm centers, 10 mm diameter, metal with nickel finish. Standard of Acceptance: Richelieu #BP6211128195 or approved alternate;
Cabinet. The Council approves major policies, which are known collectively as the Policy Framework, together with the annual Budget. The Cabinet is responsible for most day to day decisions. Overview and Scrutiny There are five Overview and Scrutiny Committees which oversee the portfolios of the Cabinet Members. They monitor the decisions of Cabinet and produce reports and recommendations, which advise the Cabinet and Council on its policies, budget and service delivery. Committees Although the Cabinet system is intended to replace most of the traditional committee structure, some committees are still needed such as Development Control, Audit and Standards Committees.
Cabinet. One (1) nine foot (9') cabinet (the "SPACE") located in the **, as further set forth in EXHIBIT A to this Addendum.
Cabinet. A Sure-Med-Registered Trademark- cabinet is a computer-controlled storage unit.
Cabinet. The University will provide a filing cabinet that locks. The filing cabinet will be located in the Union’s designated office on campus or in an area that is close to the work area of the presiding President of the AFSCME local chapter that is in agreement with the Union and the University. The key will be in the sole possession of the Union.
Cabinet. The Cabinet will consist of 10 Members with seats proportionately distributed between the Liberal Democrats (4), Labour (3), Conservative (3). The Leader will be from the largest Party. The Performance Portfolio will be given added responsibility to conduct a Review of Governance as required by the Local Government and Public Involvement in Health Xxx 0000 and bring forward proposals to Cabinet for consideration by 1st November 2008 and thereafter to manage the appropriate public consultation prior to a discussion by Full Council in March or April 2009. The Cabinet for 2008/09 would therefore be: Leader: Cllr Xxxxxxxxx (Lib Dem) Deputy Leader and Cabinet Member for Childrens Services: Cllr P Xxxx (Labour) Deputy Leader and Cabinet Member for Corporate Services: Cllr Xxx Xxxxx (Conservative) Cabinet Member – Performance: Cllr Xxxxxx-Xxxxxx Cabinet Member – Regeneration: Cllr Xxxxx Cabinet Member – Communities: Cllr Xxx Xxxxxx Cabinet Member – Environmental: Cllr Tattersall Cabinet Member – Health and Social Care: Cllr Xxxxx Cabinet Member – Leisure and Tourism: Cllr Lord Xxxxx Cabinet Member – Technical Services: Cllr Xxxxxxxxxx
Cabinet. For printer. With plexiglass cover to protect printer from dust and vapour, and storage area for extra paper.
Cabinet. 97. Vote of no confidence in Government. PART IV EXECUTIVE FUNCTIONS 98. Executive functions of President.
Cabinet. The Contractor shall check the general condition of the controller cabinet. Clean cabinet and components thoroughly, replace disposable filters, clean permanent filters, lubricate locks and hinges, check door seals, check condition of cabinet caulking at the cabinet base and re-caulk if necessary. Remove posters, tape, and graffiti from cabinet surface. Check the thermostat, fan, cabinet light, and convenience outlet for proper operation. Verify that the thermostat is set at 85 degrees as defined by the Owner. Verify that anchor bolts and ground rod clamp(s) are tight. Ensure that all field wiring is identified with tags, indicating phase and direction. Tag field wiring that is not identified. Check field wire connections. Tighten field wire connections as needed. Report problems and noted areas of concern to the Owner. In cases of infestation by mice, etc. the Contractor shall notify the Owner, take appropriate safety precautions, and immediately remove nesting material and debris. Poison shall be placed in the cabinet. Required actions to limit the possibility for future infestation shall be noted and reported to the Owner.
