BWP Loss of Load. The “Excluded 15-Minute Periods” begins with the15- Minute period in which a loss of load greater than 8 MW occurs and extending through and including one additional 15-minute period.
BWP Loss of Load Sample Clauses
Related to BWP Loss of Load
Loss of a Facility Hub In the event that BellSouth loses a facility hub, the recovery process is much the same as above. Once the NMC has observed the problem and administered the appropriate controls, the ECC will assume authority for the repairs. The recovery effort will include
Loss of Use The total and permanent loss:
Damage or Loss of Equipment 2.2.1. All devices are covered by a manufacturer’s warranty. The warranty covers manufacturer’s defects and normal use of the device. It does not cover negligence, abuse or malicious damage.
Loss of Licence The Beneficiary ceases to be authorised to be the operator of trains by a licence granted under section 8 of the Act or by a licence or SNRP granted or recognised under the Railway (Licensing of Railway Undertakings) Regulations 2005 (whether by revocation or otherwise) unless it is exempt from the requirement so to be authorised;
Loss of Data In the event of loss of any State data or records where such loss is due to the intentional act, omission, or negligence of the Contractor or any of its subcontractors or agents, the Contractor shall be responsible for recreating such lost data in the manner and on the schedule set by the Contract Manager. The Contractor shall ensure that all data is backed up and is recoverable by the Contractor.
Scaling Lost Products The volume of lost products shall be determined by the best methods currently available, using data from the records for the period in which the loss occurred or the most applicable period if loss should occur substantially after cutting. In the absence of specific information indicating size or species of lost products, species distribution and volume for entire truckloads shall be assumed to be the same as the average volume Scaled per truck during the report period, and for individual products it shall be assumed that the volume and species were the average volume of the highest priced species Scaled during the report period. B6.851 Scaling Lost Sample Loads. If Scal- ing is being done by sampling loads of logs, Purchaser shall present such sample loads for Scaling by Forest Service. If loads of logs selected to be sample Scaled are placed in the decks before they are Scaled, they will be considered as lost sample loads. It will be difficult, if not impossible, to determine the volume and species con- tained in such loads for payment purposes. Therefore, lost sample loads will be deemed to have a Scale volume and species composition equal to that of the highest value load Scaled during the sampling period, as estab- lished by Forest Service. If no sample loads were Scaled during the period, the Scale data for the high valued load will be taken from the most current preceding sampling period with Scale. Sample loads lost as a result of Forest Service actions shall be treated as non-Scaled loads.
DATA LOSS The Company does not accept responsibility for the security of Your account or content. You agree that Your use of the Website or Services is at Your own risk.
RISK OF LOSS OR DAMAGE From the point the equipment leaves Company’s office in El Cajon, CA the Customer assumes all risks of loss or damage to the equipment from any cause.
Rate Redetermination after Catastro- phic Damage In event of Catastrophic Damage and ad- justment, if any, of Included Timber, Contracting Officer shall make an appraisal to determine for each species the catastrophe-caused difference between the appraised unit value of Included Timber remaining immediately prior to the catastrophe and the appraised unit value of existing and potential Included Timber immediately after the ca- tastrophe. Included Timber is any that would not be elimi- nated under B8.32. Potential Included Timber is any that would be added under B8.32. Tentative Rates and Flat Rates in effect at the time of catastrophe shall be adjusted by said differences to be- come the redetermined rates for the purpose of a contract modification under B8.32. Accordingly, Base Rates shall be adjusted to correspond to the redetermined rates if redetermined rates are less than the original Base Rates, subject to new Base Rate limitations of 25 cents per hun- dred cubic feet or equivalent. However, existing Base In- dices shall not be changed under this Subsection. Upon agreement under B8.32, redetermined rates and Required Deposits shall be considered established under B3.1 for timber Scaled subsequent to Catastrophic Damage. At time of such appraisal, Specified Road construc- tion cost shall include the estimated cost of any construc- tion work listed in the Schedule of Items performed and abandoned.
LIABILITY AND RISK OF LOSS - PRODUCT LIABILITY With respect to products or processes resulting from a Party's participation in an SAA, each Party that markets, distributes, or otherwise provides such product, or a product designed or produced by such a process, directly to the public will be solely responsible for the safety of the product or process.
