Broadway. The Broadway banners are finished size 48 inches by 144 inches. The sponsor logo cannot be more than 5% of the banner area or 345 square inches on the banner. There should be a 6 inch top pocket for the banner arm to go completely through the banner. There is also a grommet just below the top pocket and next to the pole side edge of the banner. There shall be a large grommet at the bottom corner of the banner that is next to the pole. The banner is connected to the pole only by this grommet. The outside edge of the banner swings freely with the wind. Please reinforce the area around this bottom grommet as this has been a problem area in the past due to extremely high winds coming off the San Diego Bay. The Park and Harbor Drive banners are finished size 30 inches by 94 inches. Any commercial message cannot be more than 5% of the banner area or 141 square inches on the banner. There should be a 4- inch top and bottom pocket for the two banner bracket arms to go completely through the banner. There is also a grommet just below the top pocket and next to the pole side edge of the banner. There is also a grommet just above the bottom pocket and next to the pole side edge of the banner. It may be best not to design in the upper and lower 4 inches of the banner as there will be stitching in that area due to sewing of the pole pockets mentioned above.
Appears in 1 contract
Sources: Downtown San Diego Street Banner Program Application and Agreement
Broadway. The Broadway banners are finished size 48 inches by 144 inches. The sponsor logo cannot be more than 5% of the banner area or 345 square inches on the banner. There should be a 6 inch top pocket for the banner arm to go completely through the banner. There is also a grommet just below the top pocket and next to the pole side edge of the banner. There shall be a large grommet at the bottom corner of the banner that is next to the pole. The banner is connected to the pole only by this grommet. The outside edge of the banner swings freely with the wind. Please reinforce the area around this bottom grommet as this has been a problem area in the past due to extremely high winds coming off the San Diego Bay. The Park and Harbor Drive banners are finished size 30 inches by 94 inches. Any commercial message cannot be more than 5% of the banner area or 141 square inches on the banner. There should be a 4- 4-inch top and bottom pocket for the two banner bracket arms to go completely through the banner. There is also a grommet just below the top pocket and next to the pole side edge of the banner. There is also a grommet just above the bottom pocket and next to the pole side edge of the banner. It may be best not to design in the upper and lower 4 inches of the banner as there will be stitching in that area due to sewing of the pole pockets mentioned above.
Appears in 1 contract
Sources: Downtown San Diego Street Banner Program Application & Agreement