Blower Clause Samples
The 'Blower' clause defines the responsibilities and specifications related to the provision, installation, or maintenance of a blower device within a contract. Typically, this clause outlines the technical requirements the blower must meet, such as capacity, safety standards, and operational guidelines, and may specify who is responsible for its upkeep or replacement. By clearly assigning duties and setting performance standards for the blower, this clause helps prevent disputes over equipment quality and ensures the blower functions as intended throughout the contract term.
Blower. Coffeyville agrees to permit Chaparral, at Chaparral’s election and at Chaparral’s sole cost and expense, to design, manufacture, procure, permit, fabricate, construct, erect, install, own, and locate in the Feeder Line a blower, along with all equipment and ancillary facilities necessary for such blower, at a location mutually agreed upon by the Parties for purposes of increasing pressure of the Contract Volume at the Title Transfer Point (collectively, “Blower”). In the event Chaparral so elects, then Coffeyville agrees to operate and maintain the Blower; provided, Chaparral will reimburse Coffeyville for all reasonable actual costs and expenses incurred in operating and maintaining the Blower on a Monthly basis at pass through rates with no markup.
Blower. The blower system for the machine generates air pressure/flow to carry the seed or other input products through the system to the implement. A hydraulic motor drives the blower system. Two 3/4 inch hydraulic lines supply oil to the blower. The only part on the blower that can be serviced is the shaft seal. The shaft seal can be replaced if the motor leaks at the shaft. Do not disassemble the motor to replace the shaft seal. The shaft seal is fastened by a snap ring and can be removed with a seal pick.
Blower. No design work is foreseen for the blower, however the existing rotary vane blower is replaced by a new blower with properties as specified in the process parameters in section 3.1.2
Blower as a person covered by this Agreement who makes public allegations of inefficiency or impropriety in government. No provision of this Agreement shall be deemed to interfere with such an employee in the exercise of his or her constitutional rights of free speech, and such person shall not be discriminated against in this employment with regard thereto.
Blower. 7.1 The blower shall be rated at not less than 20,000 CFM. The fan shall be rated by an independent test facility.
7.2 The blower shall be driven by a five (5) "V" groove power belt for maximum performance and simplicity of construction, with tension adjustment not requiring repositioning of the engine.
7.3 The blower shall be a turbine type, with 9 vanes, 31 3/8 in. diameter constructed of abrasion resistant steel and fully balanced for longevity of fan and bearing life. A die-cast aluminum alloy or steel open face blower covered with rubber or not, will not be acceptable.
7.4 The blower housing shall be constructed of 10 gauge abrasion resistant steel and lined with Linatex (or equal) for maximum extended wear in abrasive environments.
7.5 The blower housing shall have an inspection door for quick inspections without removing the blower housing or looking into the air exhaust opening. Access to this inspection door must be possible without tilting the ▇▇▇▇▇▇.
7.6 The blower housing shall not be an integral part of the ▇▇▇▇▇▇. Replacement of the blower housing must not require any cutting and welding of the housing and or ▇▇▇▇▇▇.
7.7 The blower shall be mounted on heavy-duty re-greasable bearings, capable of being greased from ground level. Greasing of the bearings must be possible without tilting the ▇▇▇▇▇▇.
Blower. Boiler shall be equipped with a pulse width modulating blower system to precisely control the fuel/air mixture to provide modulating boiler firing rates for maximum efficiency. The burner firing sequence of operation shall include pre-purge, firing, modulation, and post-purge operation.