Adhesive Sample Clauses

Adhesive. Adhesive shall be synthetic resin type complying with B.S. 1204. Part 1, type WBP.

Adhesive. 1. The retroreflective sheeting shall comply with the liner removal and adhesion requirements contained in ASTM D4956-04 sections 6.8 and 6.9

Adhesive. Adhesive for rigid board insulation shall be a system approved by the board manufacturer for the underlying substrate.

Adhesive. Adhesive shall be water resistant resins and shall be non-staining.

Adhesive. Gay-Lourd with oil dry, spray adhesive, grease Location Florence, SC Quantity: 1

Adhesive. The adhesive to be used throughout should be a two-part polyurethane (such as Ciba-Geigy XB5090/1 resin with XB5304 hardener, or equivalent). Figure 5 Layer 1 Layer 5 Layer 3 Layer 2 Layer 4 1.4.1.2. Aluminium honeycomb certification and simulator characterization 1.4.1.2.1. A certificate of the aluminium honeycomb performances will be necessary to ensure that the prescriptions of the above paragraph 1.4.1.1. will be fulfilled. 1.4.1.3. Simulator performance check 1.4.1.3.1. To ensure the proper behaviour of the speaker simulator, the TS shall ensure that the force-deformation curve will lay within the limits stated in Figure 6. Figure 6 Force (kN) peaker simulator force-deformation corridor 8 6 4 1.4 0.6 10 11

Adhesive a. The permit front is designed to adhere to the inside of a vehicle’s windshield for correct image readability from the outside. The adhesive (typically 1.0 to 1.1 mil.) must adhere to the windshield in cold temperatures (-30 to -40 degrees below zero Fahrenheit) and hot temperatures (250 to 300 degrees Fahrenheit). The adhesive must not damage any plastic coatings on the inside of windshields. b. Minnesota State Parks permit holders must be able to remove the permit from the windshield once the permit has expired. 2 mil. clear polyester film (such as Mylar®) (not dry seal or GMX) coated with a permanent, pressure-sensitive acrylic adhesive and backed with a translucent (glassine) release liner. A substrate such as Flexcon Flexmark® PM 200 Clear TC-249 V-23 60 PF Glassine works well.

Adhesive backed decals (stick-on) or similar items (except nametags) may not be distributed or used in the OCCC.

Adhesive. 3.1 The permit front is designed to adhere to the inside of a vehicle’s windshield for correct image readability from the outside. The adhesive (permanent acrylic, #07) must adhere to the windshield in cold temperatures (-40 °F) and hot temperatures (180 °F). The adhesive must not damage any plastic coatings on the inside of windshields. 3.2 Minnesota state parks permit holders must be able to remove the permit from the windshield once the permit has expired. 4 mil. clear vinyl film coated with a permanent, pressure-sensitive acrylic adhesive and backed with a white release liner.