INTERIOR CONSTRUCTION Sample Clauses

INTERIOR CONSTRUCTION. The interior surface of each cart must be smooth and free from crevices, recesses, projections, and other obstructions where material inside the cart could become trapped.

INTERIOR CONSTRUCTION. The Leased Premises are leased "as is".

INTERIOR CONSTRUCTION. The construction of Tenant's space, including any Tenant finish or improvements, shall be completed pursuant to Exhibit D attached hereto.

INTERIOR CONSTRUCTION. 42 26.6 Relocation of Leased Premises.............................42 26.7

INTERIOR CONSTRUCTION. Walls Ceilings Interior Finishes Entrance Vestibule: Ground Floor Lobby: Elevator Lobbies: Egress Corridors: Restrooms: Mechanical and Electrical Rooms: Janitor’s Closet: Exit Stairs:

INTERIOR CONSTRUCTION. Unless the Leased Premises are leased "as is", the construction of the Tenant's space, including any Tenant finish or improvements shall be completed pursuant to Exhibits C and D.

INTERIOR CONSTRUCTION. 12 INTERIOR FINISHES................................................................................................................... 13 SPECIALTIES................................................................................................................................ 15 ELEVATOR.................................................................................................................................... 16 FIRE PROTECTION...................................................................................................................... 16 HEATING, VENTILATION AND AIR CONDITIONING........................................................... 16 BUILDING AUTOMATION SYSTEM......................................................................................... 18 PLUMBING................................................................................................................................... 19 ELECTRICAL................................................................................................................................ 19

INTERIOR CONSTRUCTION a) The Owner shall construct the City Space to Base Building Standards entirely at its own costs. For the purpose of this Term sheet, "Base Building Standards" means: basic improvements including but not limited to, concrete floors (ready for application of a final finish); perimeter walls dry-walled, taped, sanded and primed; life safety systems and emergency lighting; lighting; electrical panel; heating and cooling and ventilation; plumbing (excluding internal distribution) as set out in this Term Sheet. b) The flooring, ceiling and wall finishes shall be constructed as set out in this Term Sheet. The City Space on turnover to the City will meet all the Ontario Building Code requirements, City By-law requirements and accessibility requirements, as well as health and safety requirements assuming the space is operated as an open-concept office on the second floor. The City and the Owner's architect will work to properly construct the City Space, as a quality of finishes consistent with the City standards and requirements necessary to operate the space to the satisfaction of the City as set out in this Term Sheet. c) The Owner's requirement on the type and degree of interior finish includes this section and attached Appendix "A" as well as any additional matters to which the parties, acting reasonably, agree. d) For greater certainty, the Owner acknowledges and agrees that it will be responsible at its sole cost for the initial and ongoing responsibility to install, supply, repair and maintain all the mechanical components servicing the City Space, without limitation this includes the HVAC system servicing the City Space, the electrical power and panel coming into the City Space, the plumbing coming into and outgoing from the City Space, including the installation of check meters for incoming hot and cold water supply lines, the sprinkler system and life and safety equipment, and the required intake and exhaust ventilation system. e) For greater certainty, the City Space shall have at minimum the following: Heating ventilation and air conditioning provided to the City Space. This will include the distribution network that will meet ASHRAE standards, an electrical panel and appropriate distribution of the electrical requirements to operate the City Space, the necessary plumbing system that would be required or requested by the City, this would include but not be limited to bathrooms, janitorial closet, kitchen and any other requirements needed by the City fo...

INTERIOR CONSTRUCTION. 4.01 The Company normally installs exposed wiring in buildings except as follows: (a) If an applicant, customer or builder provides suitable conduit or other means of concealment, which is acceptable to the Company, the latter installs wiring in it without additional charges. (b) Subject to the following conditions, the Company installs concealed wiring in a residential dwelling during construction without additional charge if requested sufficiently in advance by a duly authorized person: (1) The size of the building and the type and stage of construction are, in the Company's opinion, are suitable for the work to be performed. (2) The Company decides the type of wiring to be used and the method of installing it. (3) Should the wiring become unusable after its installation, the Company installs other inside wiring by one of the other methods described in this Section. (4) The Company does not guarantee that subsequent changes in or additions to wiring installed during construction will be concealed.