Disassembly. You may not reverse engineer, decompile, disassemble or in any other way try to gain access to information regarding the construction of The Software.
Disassembly. 1. Disconnect power source to motor.
Disassembly. You may not modify this product in any manner. You shall not, nor allow others to copy, in whole or in part, emulate, sub‐licence, sell, transfer, exploit, alter, modify or adapt the Software Product nor decompile, dissemble or reverse engineer the same nor attempt to do such thing.
Disassembly. The Licensee shall not, and shall not permit any Licensee Personnel, Users, or third parties to: modify, create a derivative work of, clone, reverse engineer, decompile, disassemble or in any other way try to gain access to information regarding the construction of the Product(s).
Disassembly. Greenwich shall disassemble each Engine as requested by Customer in Article 3.1(A) above.
Disassembly. Where required, items such as boardroom tables, meeting room tables or corner desks will require disassembly for handling and delivery. Should disassembly be required, a disassembly fee is applied (it is usually around $25, however the disassembly of more complex items may attract a higher fee). These fees appear in the GFH website ‘checkout’ process next to the relevant items.
Disassembly. You may not reverse engineer, decompile, disassemble or in any other way try to gain access to information regarding the construction of the Software or the Product.
Disassembly. You may not reverse engineer, decompile, or disassemble the SOFTWARE PRODUCT, except and only to the extent that such activity is expressly permitted by applicable law notwithstanding this limitation of components. The SOFTWARE PRODUCT is licensed as a single product. Its component parts may not be separated for use on more than one computer. NOT FOR RESALE SOFTWARE. If the SOFTWARE PRODUCT is labeled "Not for Resale" or "NFR" or "Evaluation Copy", then, notwithstanding other sections of this XXXX, you may not sell, or otherwise transfer for value, the SOFTWARE PRODUCT.
Disassembly. ❏ The disassembly process is divided into the unit disassembly and the module disassembly. First perform the unit disassembly; then proceed to the module disassembly after the components have been disassembled into modules. ❏ Disassembly of printer components beyond the exploded diagrams at the end of this manual may result in damage to the printer and its functions. ❏ <Check> and <Reassembly Point> are given in “Disassembly step” with ★ and ✩ symbols. Make sure to follow the instructions given in these places when disassembly and reassembly. ❏ New wire bands are required when reassembly for wire bands cut during disassembly. See page 6-29 and “Part name” in the disassembly steps for types and numbers of wire bands. ❏ The numbers in the illustrations indicate the step numbers. Component Configurations Overview The EU-T532 / T542 have two disassembly types for ASP (After Service Parts) replacement. The one is “Unit disassembly” for disassembling the EU-T532 / T542 into modules, the other one is “Module Disassembly” for disassembling each module into small parts. The configurations when performing those disassemblies are as follows:
Disassembly. You must not disassemble, decompile, reverse engineer Software or otherwise modify Software or any part thereof, including source code, unless you are specifically permitted by Licensor in writing.
