Part Load means the cooling load (Pc(Tj)) or the heating load (Ph(Tj)) [kW] at a specific outdoor temperature Tj, calculated as the design load multiplied by the part load ratio;
Part Load means a shutdown of a part of the system resulting in failure of power supply,either from external connections or from the healthy part of the system.
Part Load. (PC(Tj)) means the refrigeration load at a specific ambient temperature (Tj), calculated as the full load multiplied by the part load ratio of high temperature process chillers corresponding to the same ambient temperature Tj and expressed in kW at two decimal places;
Examples of Part Load in a sentence
Attach copy of manufacturer’s performance sheet showing both Full Load (FL) and Integrated Part Load Value (IPLV) efficiencies (KW/ton).
Unit shall operate with an Inverse Efficiency Curve, with known Part Load Value Efficiencies.
Incentives for chillers shall be calculated using FL (Full Load) and IPLV (Integrated Part Load Value) efficiency ratings.
Key Assumptions: • IPLV = Integrated Part Load Factor - The term IPLV is used to signify the cooling efficiency related to a typical (hypothetical) season rather than a single rated condition.
Part Load Generator Terminal Efficiency, System 5 2–12Figure 3-1.
More Definitions of Part Load
Part Load means the operating state of the Facility during which all of the Units are operated at the minimum load consistent with Accepted Electrical Practices, which is presently expected to be sixty percent (60%) of Full Load and the Facility’s duct burners are turned off.
Part Load. (PL) means the operating point of the water pump at 75 % of the flow at BEP;
Part Load means a half (1/2) ton truck or equivalent at less than sixty percent (60%) capacity;
Part Load means a full size truck or van at less than seventy five percent (75%) capacity.
Part Load means the Combustion Turbine is not operated at greater than 60% load following the applicable Start and before its next Shutdown. “Normal Load” means the Combustion Turbine is operated at greater than 60% load following the applicable Start and before its next Shutdown.
Part Load means the operation of the plant at 50% design capacity, including but not limited to, all augmentation equipment, such as water injection;