Regulation No. 37 Revision 4 - Amendment 1 Supplement 26 to the 03 series of amendments - Date of entry into force: 4 July 2006 UNIFORM PROVISIONS CONCERNING THE APPROVAL OF FILAMENT LAMPS FOR USE IN APPROVED LAMP UNITS OF POWER-DRIVEN VEHICLES AND OF THEIR TRAILERS UNITED NATIONS ∗/ Former title of the Agreement: Agreement Concerning the Adoption of Uniform Conditions of Approval and Reciprocal Recognition of Approval for Motor Vehicle Equipment and Parts, done at Geneva on 20 March 1958. GE.06-25417 E/ECE/324 E/ECE/TRANS/505 Regulation No. 37 } Rev.1/Add.36/Rev.4/Amend.1 Paragraph 3.6.2., amend to read:
Regulation No. 65 Revision 1 - Amendment 2 Incorporating Supplement 6 to the original version of the Regulation - Date of entry into force: 15 October 2008 Corrigendum 1 to Supplement 6, subject of Depositary Notification C.N.561.2008.TREATIES-3 dated 7 August 2008 UNIFORM PROVISIONS CONCERNING THE APPROVAL OF SPECIAL WARNING LAMPS FOR MOTOR VEHICLES UNITED NATIONS ∗/ Former title of the Agreement: Agreement Concerning the Adoption of Uniform Conditions of Approval and Reciprocal Recognition of Approval for Motor Vehicle Equipment and Parts, done at Geneva on 20 March 1958.
Regulation No. 60 of the Department Regulations shall be amended in the last portion thereof to read as follows: “Drill or instruction periods of a minimum of two (2) hours shall be carried out daily except Saturdays, Sundays and holidays. Drill or instruction periods may be carried out on Saturdays at the discretion of the Captain.” At the sole discretion of the City: Company training, drill and/or instruction may be carried out on Saturdays for specialty training programs, or for emergency medical training that relates to relicensing requirements (Alternate Route for Maintenance of Licensure Program or equivalent), or for training on new or revised medical procedures, equipment, technologies, by trainers so designated by the City. Any training, drill and/or instruction may be conducted on Saturdays at stations designated as Training Stations
Regulation No. 57 Revision 1 - Amendment 1 Supplement 3 to the 01 series of amendments - Date of entry into force: 27 April 1998 UNIFORM PROVISIONS CONCERNING THE APPROVAL OF HEADLAMPS FOR MOTOR CYCLES AND VEHICLES TREATED AS SUCH UNITED NATIONS _____________ */ Former title of the Agreement: Agreement Concerning the Adoption of Uniform Conditions of Approval and Reciprocal Recognition of Approval for Motor Vehicle Equipment and Parts, done at Geneva on 20 March 1958. GE.98- E/ECE/TRANS/505¡ E/ECE/324 Rev.1/Add.56/Rev.1/Amend.1 Regulation No. 57 page 2 Paragraph 5.4.1.1., footnote 5/, amend to read: “5/ ..... 30 (vacant), 31 for Bosnia and Xxxxxxxxxxx, 00-00 (xxxxxx), 00 xxx Xxxxxx, 00-00 (xxxxxx) and 40 for The former Yugoslav Republic of Macedonia. Subsequent numbers ..... to the Agreement Concerning the Adoption of Uniform Technical Prescriptions for Wheeled Vehicles, Equipment and Parts which can be Fitted and/or be Used on Wheeled Vehicles and the Conditions for Reciprocal Recognition of Approvals Granted on the Basis of these Prescriptions, ” Annex 4, paragraph 1.2.1.1., replace by the following text (including also a new footnote 4/):
Regulation No. 5: This policy is subject to regulation 5 of IRDA (Protection of Policy Holder interest) regulation.
Regulation No. 1227/2011 pertaining to the integrity and transparency of the whole sale electricity market (provision in EU L 326, 8.12.2011 – hereinafter „the REMIT Regulation“) and the Implementing Regulation of the Commission (EU) No. 1348/2014 pertaining to data publishing (hereinafter „the REMIT Implementing Regulation“).
Regulation No. 85 Contents Uniform provisions concerning the approval of internal combustion engines or electric drive trains intended for the propulsion of motor vehicles of categories M and N with regard to the measurement of net power and the maximum 30 minutes power of electric drive trains Page
Regulation No. 7 Contents Uniform provisions concerning the approval of front and rear position lamps, stop-lamps and end-outline marker lamps for motor vehicles (except motor cycles) and their trailers Page Annexes Scope .............................................................................................................................................. 4 1. Definitions........................................................................................................................................ 4 2. Application for approval .................................................................................................................. 5 3. Markings .......................................................................................................................................... 6 4. Approval........................................................................................................................................... 7 5. General specifications ...................................................................................................................... 10
Regulation No. 76 Amendment 1 01 series of amendments **/ - Date of entry into force: 12 September 2001 UNIFORM PROVISIONS CONCERNING THE APPROVAL OF HEADLAMPS FOR MOPEDS EMITTING A DRIVING BEAM AND A PASSING BEAM UNITED NATIONS */ Former title of the Agreement: Agreement Concerning the Adoption of Uniform Conditions of Approval and Reciprocal Recognition of Approval for Motor Vehicle Equipment and Parts, done at Geneva on 20 March 1958. **/ Not requiring changes in the approval number (TRANS/WP.29/815, para. 82). GE.01- E/ECE/324 Rev.1/Add.75/Amend.1 E/ECE/TRANS/505? Regulation No. 76 page 2 Paragraph 5.4.1.1., footnote 5/, amend to read: “5/ 1 for Germany, 2 for France, 3 for Italy, 4 for the Netherlands, 5 for Sweden, 6 for Belgium, 7 for Hungary, 8 for the Czech Republic, 9 for Spain, 10 for Yugoslavia, 11 for the United Kingdom, 12 for Xxxxxxx, 00 for Luxembourg, 14 for Xxxxxxxxxxx, 00 (xxxxxx), 16 for Norway, 17 for Finland, 18 for Denmark, 19 for Romania, 20 for Poland, 21 for Portugal, 22 for the Russian Federation, 23 for Greece, 24 for Xxxxxxx, 00 for Xxxxxxx, 00 for Slovenia, 27 for Xxxxxxxx, 00 for Belarus, 29 for Xxxxxxx, 00 (xxxxxx), 00 xxx Xxxxxx xxx Xxxxxxxxxxx, 32 for Latvia, 33 (vacant), 34 for Bulgaria, 35-36 (vacant), 37 for Turkey, 38-39 (vacant), 40 for The former Yugoslav Republic of Macedonia, 41 (vacant), 42 for the European Community (Approvals are granted by its Member States using their respective ECE symbol), 43 for Japan, 44 (vacant), 45 for Australia, 46 for Ukraine and 47 for South Africa. Subsequent numbers shall be assigned to other countries in the chronological order in which they ratify or accede to the Agreement Concerning the Adoption of Uniform Technical Prescriptions for Wheeled Vehicles, Equipment and Parts which can be Fitted and/or be Used on Wheeled Vehicles and the Conditions for Reciprocal Recognition of Approvals Granted on the Basis of these Prescriptions, and the numbers thus assigned shall be communicated by the Secretary-General of the United Nations to the Contracting Parties to the Agreement.” Insert new paragraphs 14. to 14.7., to read:
Regulation No. 69 Amendment 2 Supplement 1 to the 01 series of amendments - Date of entry into force: 7 February 1999 UNIFORM PROVISIONS CONCERNING THE APPROVAL OF REAR MARKING PLATES FOR SLOW-MOVING VEHICLES (BY CONSTRUCTION) AND THEIR TRAILERS UNITED NATIONS _____________ */ Former title of the Agreement: Agreement Concerning the Adoption of Uniform Conditions of Approval and Reciprocal Recognition of Approval for Motor Vehicle Equipment and Parts, done at Geneva on 20 March 1958. GE.99-22531 E/ECE/TRANS/505¡ E/ECE/324 Rev.1/Add.68/Amend.2 Regulation No. 69 page 2 Contents, annexes, insert a new title, to read: "Annex 15 - GUIDELINES FOR INSTALLATION OF REAR MARKING PLATES ON SLOW-MOVING VEHICLES (BY CONSTRUCTION) AND THEIR TRAILERS" Paragraph 5.4.1.1., footnote */, amend to read: