Monitoring Frequency. S. No. Attribute Parameters No. of Locations Frequency of Monitoring / Data Collection 1 Meteorology Wind speed & direction, temperature, relative humidity, rainfall. Project Site Data collected from IMD 2 Ambient air quality PM10, PM2.5, SO2, NOx, and CO 8 24 hourly samples twice a week. For CO for 4 hourly s amples twice a week. 3 Noise levels Noise levels in dB(A) Leq 5 At least one day in a season for daytime and night time on a working& nonworking day. 4 Surface Water quality Physical, chemical and bacteriological parameters including pH, temperature, turbidity, magnesium hardness, total alkalinity, chloride, sulphates, fluoride, salinity, DO, BOD, COD, Heavy metals, Total coliforms, faecal coliforms, 2 Once in a Monitoring Period. 5 Ground Water quality Physical, chemical and bacteriological parameters including pH, temperature, turbidity, magnesium hardness, total alkalinity, chloride, sulphates, fluoride, salinity, DO, Heavy metals, Total coliforms, Faecal coliforms, 3 Once in a Monitoring Period. 6 Biological Environment Existing flora and fauna. Study Area 7 Soil characteristics Physical, chemical and biological parameters to assess agricultural and afforestation potential including pH, Permeability, Electrical conductivity, Nitrites, Phosphates, TPH, Fluorides, Heavy metals, SAR, Total hydrocarbons and cat-ion exchange capacity. 5 Study Area 8 Land use / Land Cover Land use for different land use Classifications. Study Area Study Area
Monitoring Frequency. Except as already provided below, PCA shall also propose to WDNR and Region 5, U.S. EPA an appropriate monitoring frequency and averaging time for each operating parameter identified by PCA as an appropriate indicator of the efficiency of its Alternative HAP Treatment Technology. PCA shall include a description of why the proposed monitoring frequency and averaging time demonstrate continuous compliance with the 1 lb./ODTP MeOH reduction required by this agreement. On a continuous basis PCA shall monitor:
Monitoring Frequency. Three separate 1-hour TSP measurements daily for a period of at least 14 days were made at the monitoring station to establish the ambient 1-hour TSP levels. For 24-hour TSP, monitoring was carried out continuously over a period of at least 14 days at the monitoring stations to establish the ambient 24-hour TSP levels. The monitoring frequency for baseline monitoring of 1-hour and 24-hour TSP is summarized in the table below: Sampling Parameter Frequency Duration 1 hour TSP • 3 times per day Consecutive days of at least 2 weeks before commencement of construction works Continuous 24-hour TSP • Daily Table 2.1: Monitoring frequency for baseline monitoring of 1-hour and 24-hour TSP
Monitoring Frequency. The baseline monitoring was measured daily for a continuous period of at least 14 consecutive days at a minimum logging interval of 30 minutes for daytime (between 0700 and 1900 hours of normal weekdays) and 15 minutes (as three consecutive Leq, (5 minutes) readings) for evening time (between 1900 and 2300 hours of normal weekdays), general holidays including Sundays (between 0700 and 2300 hours) and night-time (between 2300 and 0700 of all days). The Leq, L10 and L90 were recorded at the specified interval.
Monitoring Frequency. For the noise monitoring conducted in August 2009, the noise parameters are presented in Leq (30 min) for daytime (between 0700 and 1900 hours of normal weekdays) and Leq (15 min) for other time periods. The supplementary baseline monitoring was measured daily for a continuous period at a minimum logging interval of 30 minutes for daytime (between 0700 and 1900 hours of normal weekdays) and 15 minutes (as three consecutive Leq, (5 minutes) readings) for evening time (between 1900 and 2300 hours of normal weekdays), general holidays including Sundays (between 0700 and 2300 hours) and night-time (between 2300 and 0700 of all days). The Leq, L10 and L90 were recorded at the specified interval.
Monitoring Frequency. Liver Function Tests HbA1c (in diabetic patients only) Diabetic patients may require more frequent blood glucose monitoring due to observed reductions in glucose tolerance PSA Every 3 months Once, 3 months after initiation of degarelix As directed by specialist hospital clinician Also required if missed dose by >2 weeks
Monitoring Frequency. Table 4 shows the proposed monitoring frequency for each study site, which includes the three primary sites (i.e., Oakland, Fremont and San Xxxx) where quantification will occur and four additional sites where on-land assessments will be conducted.6 For the three primary sites, a maximum of 32 monitoring events, which include trash quantification and on-land assessments, are planned. A total of 62 additional discrete visual assessment events are also planned at these primary sites. On-land visual trash assessments at the four additional areas with high trash generation rates in San Xxxx and Oakland are planned to occur immediately before, between and immediately after street sweeping events; and before and after moderately high intensity storms.7 The total number of visual assessment events planned at these four additional sites is 152. Oakland has the most opportunities for sampling due to the daily sweeping frequency in the study area. Therefore, the frequency for conducting quantitative monitoring at the Oakland study area is such that 8 events can be monitored before and after partial trash capture devices are installed. This component will evaluate if there is a change in trash loading when partial capture devices are added as a control measure in addition to the regular street sweeping program. In addition, the Fremont study area is proposed to test street sweeping alone and the San Xxxx study area will have partial capture devices installed for the duration of the study. 6 The actual number of monitoring events that can be performed during the 18month monitoring period (November 2014-May 2016) depends on the funds remaining after preparation of the grant planning documents (i.e., Project Assessment and Evaluation Plan, Monitoring Plan, QAPP, and SAP). Therefore, the total number of monitoring events may change. 7 For the wet weather visual assessments, moderately high intensity storms should be target to the extent feasible (e.g., ≥ 0.2 inches per hour intensity).
Monitoring Frequency. The project aims to complete eight evaluations at each of the four proposed monitoring sites during dry and wet weather monitoring events. At a minimum, each site will be evaluated during wet and dry weather events, with priority given to monitoring throughout an entire storm event. Although the number of samples collected during each monitoring event will vary among sites, events, and equipment type, a minimum of three discrete samples will be collected during each event.
Monitoring Frequency. Noise measurements shall be conducted on a weekly basis. The monitoring time periods, monitoring parameters and frequency are summarised in Table 4.1. Table 4.1 Construction noise monitoring parameters and frequency Time Period (when construction activity is found) Parameters Monitoring Frequency Between 0700-1900 hours on normal weekdays Leq(30 min) Once per week Between 1900-2300 hours on normal weekdays Leq(5 min)* Between 2300-0700 hours of next day Between 0700-1900 hours on holidays * The Leq(5 min) will only be measured if construction activities are conducted. Monitoring Location In accordance with the EM&A Manual and the subsequent Baseline Report, six noise monitoring location during construction stage is required, namely:
Monitoring Frequency. For baseline, impact and post-project monitoring, monitoring should be undertaken 3 days per week, at mid- flood and mid-ebb tides, with sampling/ measurement at the designated stations. The intervals between 2 consecutive sets of monitoring should not be less than 36 hours except where there are exceedances of Action and/or Limit Level, in which case monitoring frequency should be increased. The tidal range for each of the flood and ebb tide should not be less than 0.5 m. The water quality sampling will be undertaken within a 3-hour window of 1.5 hour before and 1.5 hour after mid flood and mid-ebb tides. The Environmental Team will be responsible for liaison with the engineering contractor to confirm whether dredging/sandfilling works are being undertaken during the water quality sampling. Measurements shall be taken at 3 water depths: 1m below water surface, mid-depth and 1m above sea bed, except where the water depth less than 6m, the mid-depth station may be omitted. Should the water depth be less than 3 m, only the mid-depth station will be monitored. The ET Leader shall seek approval from the IEC and DEP on all the monitoring stations. Replicates in-situ measurements and samples collected from each independent sampling event are required for all parameters to ensure a robust statistically interpretable dataset.
