District Requirements. Teachers who do not meet District requirements will not be advanced on the Career Ladder. Credits for the District requirement may be earned by correspondence, through extension work, or on campus. Travel may be allowed when it is sponsored by an accredited institution of higher learning, credit is given, and credits are shown on a transcript.
District Requirements. The maximum number of full-time bargaining Unit Members absent for the Professional Development/Sabbatical Leave in a semester shall not exceed ten percent (10%) of faculty.
District Requirements. 9.1.7.1 The number of bargaining unit members absent for the sabbatical leave in a semester shall not exceed ten percent (10%) of faculty. To the greatest extent possible, the sabbatical leaves approved for a given academic year shall be equally distributed between semesters, and in no academic year shall the number of leaves in each semester vary by more than twenty percent (20%). The Sabbatical Leave Review Board shall consult with individuals and with divisions to achieve this number and to achieve a balance between the fall and spring semesters. If this consultation does not achieve a fall/spring semester balance and no more than the maximum number of allowable leaves per semester, the Sabbatical Leave Review Board may establish leave priorities on the basis first, of leave seniority; second, seniority at the college; and finally, by lot.
District Requirements a) Refer to and comply with the additional district requirements described in Attachment 4—Additional District Requirements.
District Requirements. A. DISTRICT will provide training to VENDOR staff prior to VENDOR participation in Program.
District Requirements. Contractor shall comply with the following: Identification: When performing work, Contractor, any subcontractors, and their employees, agents and representatives shall be in appropriate work attire (or uniform, if applicable) at all times. If Contractor does not have a specific uniform, then Contractor shall provide identification tags and/or any other mechanism the District, in its sole discretion, determines is required to easily identify Contractor’s, its subcontractors, and their employees, agents, and representatives. Contractor, any subcontractors, and their employees, agents, and representatives shall (i) display on their clothes the above-mentioned identifying information and (ii) carry photo identification and present it to any District personnel upon request. If Contractor, any subcontractors, and their employees, agents and representative cannot produce such identification or if the identification is unacceptable to District, District may provide at its sole discretion, District-produced identification tags to Contractor, costs to be borne by Contractor.
District Requirements. ⮚ Parts must be consistent with brand recommended in the Dealership’s maintenance manual. ⮚ All replacement parts are to be of a quality equal to or better than factory original ⮚ Written copy of warranty/guarantee of product is to be supplied ⮚ Deliveries must be made to appropriate facility within seventy-two (72) hours of order receipt, with exception to special order parts only. ⮚ Vendor must show proof if insurance for any carriers and/or any delivery equipment as stated in the “Instructions to Proposers Insurance” requirements, to meet minimum state standards. ⮚ All deliveries must be accompanied by the invoice or a packing slip. NO deliveries will be accepted without accompanying invoice or packing slip. ⮚ CMSD will not be responsible for loss to the vendor due to cancelled backorders that were not filled in a timely manner. ⮚ No order will be paid without an authorized purchase order number from CMSD. Confirmed orders, telephone orders, or faxed orders, without an authorized purchase order will NOT be honored. ⮚ Vendor is responsible to furnishing updated catalogues or manufacturer’s price listings, showing all price changes (if any), as they occur. ⮚ All invoices will detail the scope of repair work. ⮚ Labor shall include itemized hours with rate. ⮚ Material will show list price, % discount and actual cost. Vendors are to submit one (1) copy of their current catalog, or manufacturer’s price listing, of the products carried by their company. #21122 - SPECIFICATIONS PARTS &/OR SUPPLIES Vendors will be required to submit a percentage discount off their current catalog or manufacturer’s price listing. The name or number of the catalog is to be submitted on the Cost Proposal Form. Multiple discounts must be submitted separately and cannot be listed on one form. Please make copies of the Cost Proposal Form to submit multiple discounts (e.g. offering more than one catalog or offering more than one discount).
District Requirements. 1. The district must clearly define the procedure and communicate this to staff.
District Requirements. The District will provide to the Construction Manager full information in its possession regarding the District’s requirements for the Program.
District Requirements. PROJECT AGREEMENT This Public-Private Partnership Project Agreement (this “Agreement”) is entered into as of [●], 20[●]:
