CLASSIFICATIONS AND DEFINITIONS. The Company reserves the right to consider other relevant qualifications and experience when assessing the classification level of an employee and may in appropriate circumstances commence or advance an employee to any classification level. It is expected that alongside the technical skills listed below, a technician can demonstrate the appropriate level of commercial and customer service skills commensurate with his/her level of seniority and experience. In addition, all technicians will be expected to comply with agreed KPI’s & work in a safe manner at all times. In each year of the agreement, each Employee who has been employed with the Company for a minimum of 12 months shall receive a review of their classification levels in the period January to March. K1 - Trades Assistant • Preferred experience in forklifts or deemed competent for the role being performed. • Good reading, writing and clerical skills. • Mechanical aptitude in operation of tooling. • Must possess a current Drivers License and Forklift ticket. • Employee is required to present themselves and any company property in an acceptable condition. • Demonstrate commitment to HSE. • Behavioural standards in line with Komatsu customer support charter. • Adherence to HSE policies and procedures. • Comply with agreed KPI’s. K2 – Tradesperson • Meets all of the requirements applicable to K1. • Appropriate trade qualification for position appointed. • Carry out all PM services on all Komatsu IC & BE trucks. • Completion of two (2) Approved Technical training courses. Assessed as competent by National Training Manager for each course. • Basic troubleshooting skills across all forklift equipment systems. • Ability to follow set instructions. • Ability and desire to use hazard identification techniques (ie: Start Safe / Take 5, hazard reporting forms), demonstrate the skills to complete a JSEA. • Welding and Fabrication: Demonstrate basic welding and fabrication skills. K3 - Tradesperson • Meets all of the requirements application to K2. • Minimum of two (2) years post trade experience on forklift equipment. • Carry out all PM services on all makes & models of IC & BE trucks • Completion of four (4) Approved Technical training courses. Assessed as competent by National Training Manager for each course. • Read and interpret Komatsu IC & BE truck electrical & hydraulic circuit diagrams and take relevant readings around the circuit • Have a good understanding of the Komatsu diagnostic software – IC & BE....
CLASSIFICATIONS AND DEFINITIONS. SECTION 44.
CLASSIFICATIONS AND DEFINITIONS. 13.1. The classifications applicable to employees performing work under this agreement and the definitions applicable in relation to the work performed are contained at Appendix 3.
CLASSIFICATIONS AND DEFINITIONS. CLAUSE 6.- For the purposes hereof, the Unionized Workers rendering their services to the Company are classified in the following work fields: I. WIRES.
CLASSIFICATIONS AND DEFINITIONS. Schedule B contains the classification definitions applicable to this Agreement.
CLASSIFICATIONS AND DEFINITIONS i. The most current edition of the N.A.D.A. Official Used Car Guide (“Guide”) shall determine the classification of whether a vehicle is in fact a truck or van, or whether it is a passenger automobile. If the Guide does not contain reference to a particular vehicle, then the manufacturer’s classification shall control. If publication of the Guide shall be discontinued, an equivalent publication shall be used to determine vehicle classifications hereunder. Except as otherwise provided as to certain vans under Section 9(b)(v) above, a State registration or title classification shall have no bearing on determination of the classifications under this Section 9(c)(i).
