Reference point definition

Reference point means one of the following points:

Reference point means a special monumented point that does not occupy the same geographical position as the corner itself, and where the spatial relationship to the corner is recorded, and which serves to locate the corner.

Reference point means Ordnance Survey National Grid reference point;

Examples of Reference point in a sentence

• When the Phantom Fader is above the Trim Reference point, you are increasing the level of previously written moves.

• The points (A,B,C,D, etc) indicated on said map are defined below: Reference point Co-ordinates A B C D ANNEXE B PLAN FOR EXPLOITATION OF MINERAL RESOURCE This annexe is attached to and comprises an integral part of this Contract between the Ministry and the Contractor.

• When the Trim has been completed, move the fader to align the Phantom with the Trim Reference point.

• A Trim Reference point will appear for each Selected channel in Trim Mode.

• When the Phantom Fader is below the Trim Reference point, you are decreasing the level of the previously written moves.

More Definitions of Reference point

Reference point means a point which is defined as follows:

Reference point means a point depending on the design and category of the vehicle.

Reference point means Ordnance Survey National Grid reference point; “river” means the river Humber;

Reference point means a known point or location used to determine the location or placement of sewage disposal system components.

Reference point means a point on the earth's surface, identified in terms of latitude and longitude to the nearest second, from which all linear measurements originate when applying the criteria of this chapter to helicopter facilities. The facility reference point will always be the exact center of the helicopter touchdown area.

Reference point means a point which is defined as followsone of the following points:

Reference point means the point which is situated in the plane parallel to the median longi­ tudinal plane of the tractor passing through the middle of the seat, at a position 700 mm along the vertical above the line of intersection of that plane with the surface of the seat and 270 mm – in the direction of the pelvis support – from the vertical plane tangential to the front edge of the seat surface and perpendicular to the median longitudinal plane of the tractor (see figure 1); the reference point as thus determined applies to an empty seat adjusted in the average position prescribed by the tractor manufacturer.