Voltage Dip definition

Voltage Dip has the meaning given to it in the Grid Code;
Voltage Dip means a short-duration reduction in Voltage on any or all phases due to a Fault Disturbance or other Significant Incident, resulting in Transmission System Voltages outside the ranges as specified in the Operating Security Standard, and more generally, bus Voltages or terminal Voltages of less than 90% of nominal voltage on any or all phases. Percentage Voltage Dip shall be calculated with respect to nominal voltage.
Voltage Dip means a temporary drop (more than ½ cycle, less than a minute) in voltage magnitude below a predefined threshold (typically 90%) of the nominal voltage. When the low voltage extends longer than a minute it falls into the category of Voltage Variation, and events shorter than ½ cycle are classified as Voltage Transients.

Examples of Voltage Dip in a sentence

  • Declared voltage (Uc)Table 4: Supply Voltage Dip Limits for LV and MV Networks in Terms of Number of Events per Year.

  • Luiso, “Accuracy Analysis of Algorithms Adopted in Voltage Dip Measurements,” IEEE Trans.

  • Additional features shall include Voltage Dip time delayNormal to Emergency and emergency to normal time delays.Load Dump Control on equipment branchesPhase Failure (In Phase) MonitorPanel mounted pilot lights and auxiliary contacts for remote pilot light status panel.Note: The complete PV installation of possible battery installation will be dealt with through a separate tender process.

  • C5.13.3 Voltage Dip Ride-through Inverter (VDRI) (a) Voltage dip ride-through inverter (VDRI) shall comprise static bypass switch, energy storage capacitor, inverter and microprocessor based control circuits.

  • A Short Duration Voltage Variation is a Voltage Sag (or Voltage Dip) if the RMS value of the voltage decreases to between 10 percent and 90 percent of the nominal value.3.2.3.3 A Long Duration Voltage Variation shall be defined as a variation of the RMS value of the voltage from nominal voltage for a time greater than one minute.

  • Transient Voltage Dip : less than 15 % on application of 100 % step load.

  • And, following fault clearing, for transient and post-transient voltages remain within the following ranges: DisturbanceTransient Voltage Dip StandardPost Transient Voltage Deviation StandardN-1 (Single Contingency)Not to exceed 25% at load buses.Not to exceed 20% for more than 20 cycles at load buses.Not to exceed 5% at any bus.N-2 (DoubleContingency)Not to exceed 30% at any bus.Not to exceed 20% for more than 40 cycles at load buses.Not to exceed 10% atany bus.

  • The wedge reduces sudden loss of vehicle control by the driver due to vertical “drop-off”.

  • Open Circuit characteristicSpecial Tests (Will be witnessed by OIL)a) Voltage Regulation Testb) Transient Voltage Dip & Transient Voltage Rise [TVD/TVR] testc) Temperature rise test at rated voltage and current, power factor and frequency.

  • An Event Estimate of Expenses will be prepared and will indicate the services desired, the price, and the authorization of the Licensee or designated representative.


More Definitions of Voltage Dip

Voltage Dip means a sudden reduction of the voltage to a value between 90% and 100% of the nominal voltage
Voltage Dip has the meaning given to it in the EirGrid Grid Code. Schedule 2 Operating Reserves 1 Operating Reserve Services The following DS3 System Services are covered by this Schedule 2: Primary Operating Reserve, Secondary Operating Reserve, Tertiary Operating Reserve 1, Tertiary Operating Reserve 2 and Replacement Reserve.
Voltage Dip means a single short reduction in supply voltage as defined in AS 61000.3.100;
Voltage Dip has the meaning given to it in the EirGrid Grid Code; “Warm” means a warm Warmth State;
Voltage Dip means a single short reduction in supply voltage generally for less than 1 second. Authorised by the ACT Parliamentary Counsel—also accessible at www.legislation.act.gov.au Authorised by the ACT Parliamentary Counsel—also accessible at www.legislation.act.gov.au Authorised by the ACT Parliamentary Counsel—also accessible at www.legislation.act.gov.au Authorised by the ACT Parliamentary Counsel—also accessible at www.legislation.act.gov.au Authorised by the ACT Parliamentary Counsel—also accessible at www.legislation.act.gov.au Authorised by the ACT Parliamentary Counsel—also accessible at www.legislation.act.gov.au Authorised by the ACT Parliamentary Counsel—also accessible at www.legislation.act.gov.au Authorised by the ACT Parliamentary Counsel—also accessible at www.legislation.act.gov.au Authorised by the ACT Parliamentary Counsel—also accessible at www.legislation.act.gov.au Authorised by the ACT Parliamentary Counsel—also accessible at www.legislation.act.gov.au Authorised by the ACT Parliamentary Counsel—also accessible at www.legislation.act.gov.au Authorised by the ACT Parliamentary Counsel—also accessible at www.legislation.act.gov.au Authorised by the ACT Parliamentary Counsel—also accessible at www.legislation.act.gov.au Authorised by the ACT Parliamentary Counsel—also accessible at www.legislation.act.gov.au

Related to Voltage Dip

  • voltage means the root-mean-square value of electrical potential between two conductors.

  • high voltage means the classification of an electric component or circuit, if its working voltage is > 60 V and ≤ 1500 V DC or > 30 V and ≤ 1000 V AC root mean square (rms).

  • heat pump means a machine, a device or installation that transfers heat from natural surroundings such as air, water or ground to buildings or industrial applications by reversing the natural flow of heat such that it flows from a lower to a higher temperature. For reversible heat pumps, it may also move heat from the building to the natural surroundings;

  • Interconnector means equipment used to link the electricity system of the State to electricity systems outside of the State;

  • Diameter at breast height (dbh) means the diameter of a tree at 4 1/2 feet above the ground measured from the uphill side.

  • Generating Facility means the Generating Unit(s) comprising Seller’s power plant, as more particularly described in Section 1.02 and Exhibit B, including all other materials, equipment, systems, structures, features and improvements necessary to produce electric energy and thermal energy, excluding the Site, land rights and interests in land.

  • LSD means lysergic acid diethylamide.

  • Sewage sludge weight means the weight of sewage sludge, in dry U.S. tons, including admixtures such as liming materials or bulking agents. Monitoring frequencies for sewage sludge parameters are based on the reported sludge weight generated in a calendar year (use the most recent calendar year data when the NPDES permit is up for renewal).

  • Fiber means a glass strand or strands which is/are protected by a color coded buffer tube and which is/are used to transmit a communication signal along the glass strand in the form of pulses of light.

  • InterMTA Traffic means traffic to or from WSP’s network that, at the beginning of the call, originates in one MTA and terminates in another MTA.

  • Pump spray means a packaging system in which the product ingredients within the container are not under pressure and in which the product is expelled only while a pumping action is applied to a button, trigger or other actuator.