Technical potential definition

Technical potential means the demand and energy savings which could occur if every existing piece of equipment or operating practice were changed to a technically feasible level of energy efficiency. “Technically viable” means that a measure is appropriate for customers’ equipment and buildings
Technical potential means the demand and energy savings which could occur if every existing piece of equipment or operating practice were changed to a technically feasible level of energy effi- ciency.
Technical potential means the reduction in energy usage or peak demand that would result if all electricity consumers adopted the most efficient commercially available energy efficiency measures.

Examples of Technical potential in a sentence

  • Technical potential as evidenced by 1, 2, and 3 is evaluated during peer review and is provided a rating.

  • Technical potential yields are maximum yields with latest varieties, removing all constraints including moisture, at generally prevailing solar radiation, temperature and daylight, estimated from highly controlled on-station experiments or crop models calibrated with latest varieties, well-monitored crop trials (Evans and Fischer, 1999).

  • Technical potential assumes that all energy efficiency measures are implemented by all of ComEd’s customers, irrespective of cost or other barriers.

  • The changes appear well embedded and further implementation is being carefully managed.

  • Technical potential The ordering party does not specify the conditions in this range.

  • Technical potential can be defined as “the geographic potential after any efficiency losses of the primary to secondary conversion process are accounted for” (page 2, Köberle et al.

  • Technical potential depend on time horizon as technology evolution can unlock additional potential.

  • Technical potential also assumes the adoption of every other available measure, where applicable.

  • The latter two types—achievableand program—tend to be more useful in that they estimate what can actually be achieved, when it can be captured, and how much it will cost to do so.• Technical potential is the theoretical maximum amount of energy use that could be displaced by effi­ ciency, disregarding all non-engineering constraints such as cost-effectiveness and the willingness of end-users to adopt the efficiency measures.

  • Technical potential for CHP at industrial and commercial facilities 5Figure 5.


More Definitions of Technical potential

Technical potential means the demand and energy savings which could occur if every existing piece of
Technical potential means the reduction in energy usage or peak demand that would result if all homes and businesses adopted the most efficient measures, regardless of cost.

Related to Technical potential

  • Technical Support Services means the technical support and maintenance Services provided by us according to our then-current technical support policy and procedure listed at xxxxxxxxxxxxx.xxx (“Technical Support Policy”) when the Services are purchased.

  • Clinical evaluation means a systematic and planned process to continuously generate, collect, analyse and assess the clinical data pertaining to a device in order to verify the safety and performance, including clinical benefits, of the device when used as intended by the manufacturer;

  • Mobile crisis outreach team means a crisis intervention service for minors or families of minors experiencing behavioral health or psychiatric emergencies.

  • Technical Specifications means the detailed requirements for the Work furnished by the Architect and set forth in Book 3 of the Contract Documents.

  • Clinical nurse specialist means a registered nurse with relevant post-basic qualifications and 12 months’ experience working in the clinical area of his/her specified post-basic qualification, or a minimum of four years’ post-basic registration experience, including three years’ experience in the relevant specialist field and who satisfies the local criteria.

  • Technical safeguards means the technology and the policy and procedures for its use that 27 protect electronic PHI and control access to it.

  • QA means quality assurance.

  • Peer support specialist means an individual who has experienced a severe and persistent mental illness and who has successfully completed standardized training to provide peer support services through the medical assistance program or the Iowa Behavioral Health Care Plan.

  • LOCKHEED XXXXXX Procurement Representative means a person authorized by LOCKHEED XXXXXX'x cognizant procurement organization to administer and/or execute this Contract.

  • WorkSafeBC means the Workers Compensation Board, a provincial Crown corporation created pursuant to the Workers Compensation Act (British Columbia);

  • technical specification means, with respect to any Software, the document setting forth the technical specifications for such Software and included in the Statement of Work.

  • Clinical peer means a physician or other health care professional who holds a non-restricted license in a state of the United States and in the same or similar specialty as typically manages the medical condition, procedure or treatment under review.

  • MSAA Indicator Technical Specifications document means, as the context requires, either or both of the document entitled “Multi-Sector Service Accountability Agreement (MSAA) 2019-20 Indicator Technical Specifications November 5, 2018 Version 1.3” and the document entitled “Multi-Sector Service Accountability Agreement (MSAA) 2019-20 Target and Corridor-Setting Guidelines” as they may be amended or replaced from time to time;

  • Compression Ignition Engine means an internal combustion engine with operating characteristics significantly similar to the theoretical diesel combustion cycle. The regulation of power by controlling fuel supply in lieu of a throttle is indicative of a compression ignition engine.

  • frequency ride through as used herein shall mean the ability of a Small Generating Facility to stay connected to and synchronized with the system or equipment of the Transmission Owner and any Affected Systems during system disturbances within a range of under-frequency and over- frequency conditions, in accordance with Good Utility Practice and consistent with any standards and guidelines that are applied to other generating facilities in the Balancing Authority Area on a comparable basis. The term “voltage ride through” as used herein shall mean the ability of a Small Generating Facility to stay connected to and synchronized with the system or equipment of the Transmission Owner and any Affected Systems during system disturbances within a range of under-voltage and over-voltage conditions, in accordance with Good Utility Practice and consistent with any standards and guidelines that are applied to other generating facilities in the Balancing Authority Area on a comparable basis.

  • Technical data means recorded information, regardless of the form or method of the recording, of a scientific or technical nature (including computer software documentation). The term does not include computer software or data incidental to contract administration, such as financial and/or management information.

  • Environmental and Social Management Framework or “ESMF” means an instrument satisfactory to the Association, prepared and adopted by the Recipient and dated February 5, 2010 outlining the process for management of the environmental and social aspects of the Project as the same may be amended from time to time with the Association’s prior written concurrence.

  • Project Management Report means each report prepared in accordance with Section 4.02 of this Agreement;

  • Disinfection profile means a summary of Giardia lamblia inactivation through the treatment plant.

  • Diagnostic clinical procedures manual means a collection of written procedures that describes each method (and other instructions and precautions) by which the licensee performs diagnostic clinical procedures; where each diagnostic clinical procedure has been approved by the authorized user and includes the radiopharmaceutical, dosage, and route of administration.

  • Category 4 Data is data that is confidential and requires special handling due to statutes or regulations that require especially strict protection of the data and from which especially serious consequences may arise in the event of any compromise of such data. Data classified as Category 4 includes but is not limited to data protected by: the Health Insurance Portability and Accountability Act (HIPAA), Pub. L. 104-191 as amended by the Health Information Technology for Economic and Clinical Health Act of 2009 (HITECH), 45 CFR Parts 160 and 164; the Family Educational Rights and Privacy Act (FERPA), 20 U.S.C. §1232g; 34 CFR Part 99; Internal Revenue Service Publication 1075 (xxxxx://xxx.xxx.xxx/pub/irs-pdf/p1075.pdf); Substance Abuse and Mental Health Services Administration regulations on Confidentiality of Alcohol and Drug Abuse Patient Records, 42 CFR Part 2; and/or Criminal Justice Information Services, 28 CFR Part 20.

  • Database Management System (DBMS) A system of manual procedures and computer programs used to create, store and update the data required to provide Selective Routing and/or Automatic Location Identification for 911 systems. Day: A calendar day unless otherwise specified. Dedicated Transport: UNE transmission path between one of CenturyLink’s Wire Centers or switches and another of CenturyLink’s Wire Centers or switches within the same LATA and State that are dedicated to a particular customer or carrier. Default: A Party’s violation of any material term or condition of the Agreement, or refusal or failure in any material respect to properly perform its obligations under this Agreement, including the failure to make any undisputed payment when due. A Party shall also be deemed in Default upon such Party’s insolvency or the initiation of bankruptcy or receivership proceedings by or against the Party or the failure to obtain or maintain any certification(s) or authorization(s) from the Commission which are necessary or appropriate for a Party to exchange traffic or order any service, facility or arrangement under this Agreement, or notice from the Party that it has ceased doing business in this State or receipt of publicly available information that signifies the Party is no longer doing business in this State.

  • Basic Comprehensive User Guide means the Ministry document titled Basic Comprehensive Certificates of Approval (Air) User Guide” dated April 2004 as amended.

  • Critical Path means those Trade Contractor Work activities identified on the Construction Schedule which, if delayed, will cause a corresponding Delay in the Substantial Completion Date.

  • Child support services means any civil, criminal or administrative action taken by the Division of

  • Comprehensive resource analysis means an analysis including,